LM3S5D56 Datasheet, PDF (555/1146 Pages) Texas Instruments – Stellaris® LM3S5D56 Microcontroller

Stellaris^® LM3S5D56 Microcontroller
a column following the operational mode name (Always or Once) indicates that the interrupt or
trigger signal is de-asserted and a "1" indicates that the signal is asserted.
Figure 12-16. Mid-Band Operation (CIC=0x1 and/or CTC=0x1)
COMP1
COMP0
Always – 0 0 1 1 0 0 0 1 1 1 0 0 1 1 0 0
Once – 0 0 1 0 0 0 0 1 0 0 0 0 1 0 0 0
Hysteresis Always – - - - - - - - - - - - - - - - -
Hysteresis Once – - - - - - - - - - - - - - - - -
High-Band Operation
To operate in the high-band region, either the CIC field or the CTC field in the ADCDCCTLn register
must be programmed to 0x3. This setting causes interrupts or triggers to be generated in the
high-band region according the operation mode. An example of the state of the interrupt/trigger
signal in the high-band region for each of the allowed operational modes is shown in Figure
12-17 on page 556. Note that a "0" in a column following the operational mode name (Always, Once,
Hysteresis Always, and Hysteresis Once) indicates that the interrupt or trigger signal is de-asserted
and a "1" indicates that the signal is asserted.
January 23, 2012
555
Texas Instruments-Production Data