C8051F980-C-GM Datasheet, PDF (307/325 Pages) Silicon Laboratories – Ultra Low Power, 8-2 kB Flash, Capacitive Sensing MCU

C8051F99x-C8051F98x
Where F_PCA is the frequency of the clock selected by the CPS2–0 bits in the PCA mode register,
PCA0MD. The lower byte of the capture/compare module is compared to the PCA counter low byte; on a
match, CEXn is toggled and the offset held in the high byte is added to the matched value in PCA0CPLn.
Frequency Output Mode is enabled by setting the ECOMn, TOGn, and PWMn bits in the PCA0CPMn
register. Note that the MATn bit should normally be set to 0 in this mode. If the MATn bit is set to 1, the
CCFn flag for the channel will be set when the 16-bit PCA0 counter and the 16-bit capture/compare
register for the channel are equal.
Write to
PCA0CPLn
0
ENB
Reset
Write to
PCA0CPHn ^ENB
1
PCA0CPMn
PECCMT PE
WC A A A O WC
MO P P T GMC
1 MPN n n n F
6nnn
n
n
x 000
x
PCA0CPLn
Enable
8-bit
Comparator
8-bit Adder
PCA0CPHn
Adder
Enable
Toggle
match
TOGn
0 _{CEXn Crossbar}
1
Port I/O
PCA Timebase
PCA0L
Figure 26.7. PCA Frequency Output Mode
26.3.5. 8-bit, 9-bit, 10-bit and 11-bit Pulse Width Modulator Modes
Each module can be used independently to generate a pulse width modulated (PWM) output on its
associated CEXn pin. The frequency of the output is dependent on the timebase for the PCA counter/timer,
and the setting of the PWM cycle length (8, 9, 10 or 11-bits). For backwards-compatibility with the 8-bit
PWM mode available on other devices, the 8-bit PWM mode operates slightly different than 9, 10 and 11-
bit PWM modes. It is important to note that all channels configured for 8/9/10/11-bit PWM mode will
use the same cycle length. It is not possible to configure one channel for 8-bit PWM mode and another
for 11-bit mode (for example). However, other PCA channels can be configured to Pin Capture, High-
Speed Output, Software Timer, Frequency Output, or 16-bit PWM mode independently.
Rev. 1.2
307