SI5341_16 Datasheet, PDF (3/53 Pages) Silicon Laboratories – Low-Jitter, 10 or 4-Output, Any-Frequency, Any-Output Clock Generator

2. Ordering Guide
Si5341/40 Rev D Data Sheet
Ordering Guide
Table 2.1. Si5341/40 Ordering Guide
Ordering Part Number
(OPN)
Si5341
Si5341A-D-GM^{1, 2}
Si5341B-D-GM^{1, 2}
Si5341C-D-GM^{1, 2}
Si5341D-D-GM^{1, 2}
Si5340
Si5340A-D-GM^{1, 2}
Si5340B-D-GM^{1, 2}
Si5340C-D-GM^{1, 2}
Si5340D-D-GM^{1, 2}
Si5341/40-D-EVB
Si5341-D-EVB
Si5340-D-EVB
Note:
Number of In-
put/Output
Clocks
4/10
4/4
—
Output Clock Frequency
Range (MHz)
Frequency Syn-
thesis Mode
Package
Temperature
Range
0.0001 to 1028 MHz
0.0001 to 350 MHz
0.0001 to 1028 MHz
0.0001 to 350 MHz
0.0001 to 1028 MHz
0.0001 to 350 MHz
0.0001 to 1028 MHz
0.0001 to 350 MHz
Integer and
Fractional
Integer Only
64-QFN
9x9 mm
–40 to 85 °C
Integer and
Fractional
Integer Only
44-QFN
7x7 mm
–40 to 85 °C
—
—
Evaluation
Board
—
1. Add an R at the end of the OPN to denote tape and reel ordering options.
2. Custom, factory pre-programmed devices are available. Ordering part numbers are assigned by Silicon Labs and the ClockBuild-
er Pro software utility. Custom part number format is: e.g., Si5341A-Dxxxxx-GM, where "xxxxx" is a unique numerical sequence
representing the preprogrammed configuration.
3. See 3.9 Custom Factory Preprogrammed Devicesand 3.10 Enabling Features and/or Configuration Settings Not Available in
ClockBuilder Pro for Factory Pre-Programmed Devices for important notes about specifying a preprogrammed device to use fea-
tures or device register settings not yet available in CBPro.
silabs.com | Smart. Connected. Energy-friendly.
Rev. 1.0 | 2