C515A_9708 Datasheet, PDF (151/182 Pages) Siemens Semiconductor Group – 8-Bit CMOS Microcontroller

Power Saving Modes
C515A
The idle mode is entered by two consecutive instructions. The first instruction sets the flag bit IDLE
(PCON.0) and must not set bit IDLS (PCON.5), the following instruction sets the start bit IDLS
(PCON.5) and must not set bit IDLE (PCON.0). The hardware ensures that a concurrent setting of
both bits, IDLE and IDLS, does not initiate the idle mode. Bits IDLE and IDLS will automatically be
cleared after being set. If one of these register bits is read the value that appears is 0. This double
instruction is implemented to minimize the chance of an unintentional entering of the idle mode
which would leave the watchdog timer's task of system protection without effect.
Note:
PCON is not a bit-addressable register, so the above mentioned sequence for entering the idle
mode is obtained by byte-handling instructions, as shown in the following example:
ORL
ORL
PCON,#00000001B
PCON,#00100000B
;Set bit IDLE, bit IDLS must not be set
;Set bit IDLS, bit IDLE must not be set
The instruction that sets bit IDLS is the last instruction executed before going into idle mode.
There are two ways to terminate the idle mode:
– The idle mode can be terminated by activating any enabled interrupt. This interrupt will be
serviced and normally the instruction to be executed following the RETI instruction will be the
one following the instruction that sets the bit IDLS.
– The other way to terminate the idle mode, is a hardware reset. Since the oscillator is still
running, the hardware reset must be held active only for two machine cycles for a complete
reset.
Semiconductor Group
9-4
1997-08-01