GS2961A Datasheet, PDF (11/104 Pages) Gennum Corporation – Ancillary data extraction

Table 1-1: Pin Descriptions (Continued)
Pin
Number
E8
Name
SDIN_TDI
Timing
Type
Input
F1, G1
F7
AGCP, AGCN
CS_TMS
Input
F8
SCLK_TCK
Input
F9, F10, H9,
H10, J8, J9,
J10, K8, K9,
K10
DOUT8, 9, 6, 7, 1,
4, 5, 0, 2, 3
Output
Description
COMMUNICATION SIGNAL INPUT
Please refer to the Input Logic parameters in the DC Electrical
Characteristics table for logic level threshold and compatibility.
GSPI serial data in/test data in.
In JTAG mode (JTAG/HOST = HIGH), this pin is used to shift test data
into the device.
In host interface mode, this pin is used to write address and
configuration data words into the device.
Automatic Gain Control for the equalizer. Attach the AGC capacitor
between these pins.
COMMUNICATION SIGNAL INPUT
Please refer to the Input Logic parameters in the DC Electrical
Characteristics table for logic level threshold and compatibility.
Chip select / test mode start.
In JTAG mode (JTAG/HOST = HIGH), this pin is Test Mode Start, used
to control the operation of the JTAG test.
In host interface mode (JTAG/HOST = LOW), this pin operates as the
host interface chip select and is active LOW.
COMMUNICATION SIGNAL INPUT
Please refer to the Input Logic parameters in the DC Electrical
Characteristics table for logic level threshold and compatibility.
Serial data clock signal.
In JTAG mode (JTAG/HOST = HIGH), this pin is the JTAG clock.
In host interface mode (JTAG/HOST = LOW), this pin is the host
interface serial bit clock.
All JTAG/host interface addresses and data are shifted into/out of
the device synchronously with this clock.
PARALLEL DATA BUS
Please refer to the Output Logic parameters in the DC Electrical
Characteristics table for logic level threshold and compatibility.
20-bit mode
20bit/10bit = HIGH
SMPTE mode (SMPTE_BYPASS = HIGH
and DVB_ASI = LOW):
Chroma data output for SD and HD
data rates; Data Stream 2 for 3G data
rate
DVB-ASI mode (SMPTE_BYPASS = LOW
and DVB_ASI = HIGH):
Not defined
Data-Through mode (SMPTE_BYPASS =
LOW and DVB_ASI = LOW):
Data output
10-bit mode
20bit/10bit = LOW
Forced LOW
GS2961A 3Gb/s, HD, SD SDI Integrated Receiver
Data Sheet
54385 - 2
September 2012
11 of 104