|
K5D5657ACM Datasheet, PDF (16/74 Pages) Samsung semiconductor – 256Mb NAND and 256Mb Mobile SDRAM | |||
|
◁ |
K5D5657ACM-F015
PrelAimdvinanacrye
MCP MEMORY
Pointer Operation
Samsung NAND Flash has three address pointer commands as a substitute for the two most significant column addresses. â00hâ
command sets the pointer to âAâ area(0~255byte), â01hâ command sets the pointer to âBâ area(256~511byte), and â50hâ command sets
the pointer to âCâ area(512~527byte). With these commands, the starting column address can be set to any of a whole
page(0~527byte). â00hâ or â50hâ is sustained until another address pointer command is inputted. â01hâ command, however, is effective
only for one operation. After any operation of Read, Program, Erase, Reset, Power_Up is executed once with â01hâ command, the
address pointer returns to âAâ area by itself. To program data starting from âAâ or âCâ area, â00hâ or â50hâ command must be inputted
before â80hâ command is written. A complete read operation prior to â80hâ command is not necessary. To program data starting from
âBâ area, â01hâ command must be inputted right before â80hâ command is written.
Table 2. Destination of the pointer
Command
00h
01h
50h
Pointer position
0 ~ 255 byte
256 ~ 511 byte
512 ~ 527 byte
Area
1st half array(A)
2nd half array(B)
spare array(C)
"A" area
(00h plane)
"B" area
"C" area
(01h plane) (50h plane)
256 Byte
256 Byte
16 Byte
"A"
"B"
"C"
Internal
Page Register
Pointer select
commnad
(00h, 01h, 50h)
Pointer
Figure 3. Block Diagram of Pointer Operation
(1) Command input sequence for programming âAâ area
The address pointer is set to âAâ area(0~255), and sustained
Address / Data input
00h
80h
10h
00h
Address / Data input
80h
10h
âAâ,âBâ,âCâ area can be programmed.
It depends on how many data are inputted.
â00hâ command can be omitted.
(2) Command input sequence for programming âBâ area
The address pointer is set to âBâ area(256~512), and will be reset to
âAâ area after every program operation is executed.
Address / Data input
Address / Data input
01h
80h
10h
01h
80h
10h
âBâ, âCâ area can be programmed.
It depends on how many data are inputted.
â01hâ command must be rewritten before
every program operation
(3) Command input sequence for programming âCâ area
The address pointer is set to âCâ area(512~527), and sustained
Address / Data input
Address / Data input
50h
80h
10h
50h
80h
10h
Only âCâ area can be programmed.
â50hâ command can be omitted.
- 16 -
Revision 0.1
September 2003
|
▷ |