M37281EKSP Datasheet, PDF (56/172 Pages) Renesas Technology Corp – SINGLE-CHIP 8-BIT CMOS MICROCOMPUTER with CLOSED CAPTION DECODER and ON-SCREEN DISPLAY CONTROLLER

M37281MAH–XXXSP,M37281MFH–XXXSP,M37281MKH–XXXSP, M37281EKSP
8.10.1 Notes When not Using Data Slicer
When bit 0 of data slicer control register 1 (address 00E016) is “0,”
terminate the pins as shown in Figure 8.10.2.
<When data slicer circuit and timing signal generating circuit is in OFF state>
Apply the same voltage as VCC to
AVCC pin.
(✽)
Apply HLF pin VCC or VSS level.
Apply VHOLD pin VCC or VSS level.
Pull-up CVIN pin to VCC through
a resistor of 5 kΩ or more.
VCC or VSS
VCC or VSS
18 ^AVCC
19 ^HLF
21 ^VHOLD
VCC or VSS ₂₂ CVIN
(✽) Only M37281EKSP have AVCC pin.
This pin is non-connection pin in M37281MAH-XXXSP, M37281MFH-XXXSP,
M37281MKH-XXXSP.
But NC pin of M37281MAH-XXXSP, M37281MFH-XXXSP, M37281MKH-XXXSP
is not connect in the IC.
You can apply to Vcc.
Fig. 8.10.2 Termination of Data Slicer Input/Output Pins when Data Slicer Circuit and Timing Generating Circuit Is in OFF State
When both bits 0 and 2 of data slicer control register 1 (address
00E016) are “1,” terminate the pins as shown in Figure 8.10.3.
<When using a reference clock generated in timing signal generating circuit as OSD clock>
Apply the same voltage as VCC to AVCC pin.
(✽)
Connect the same external circuit as when
using data slicer to HLF pin.
1 µF
Leave VHOLD pin open.
1 kΩ
200pF
18 ^AVCC
19 ^HLF
Open ₂₁ VHOLD
Pull-up CVIN to VCC through a resistor
of 5 kΩ or more.
5 kΩ or more
22 ^CVIN
(✽) Only M37281EKSP have AVCC pin.
This pin is non-connection pin in M37281MAH-XXXSP, M37281MFH-XXXSP,
M37281MKH-XXXSP.
But NC pin of M37281MAH-XXXSP, M37281MFH-XXXSP, M37281MKH-XXXSP
is not connect in the IC.
You can apply to Vcc.
Fig. 8.10.3 Termination of Data Slicer Input/Output Pins when Timing Signal Generating Circuit Is in ON State
Rev.1.01 2003.07.16 page 56 of 170