M37281EKSP Datasheet, PDF (43/172 Pages) Renesas Technology Corp – SINGLE-CHIP 8-BIT CMOS MICROCOMPUTER with CLOSED CAPTION DECODER and ON-SCREEN DISPLAY CONTROLLER

M37281MAH–XXXSP,M37281MFH–XXXSP,M37281MKH–XXXSP, M37281EKSP
8.6.10 Example of Master Transmission
An example of master transmission in the standard clock mode, at
the SCL frequency of 100 kHz and in the ACK return mode is shown
below.
➀ Set a slave address in the high-order 7 bits of the I²C address
register (address 00F716) and “0” in the RBW bit.
➁ Set the ACK return mode and SCL = 100 kHz by setting “8516” in
the I²C clock control register (address 00FA16).
➂ Set “1016” in the I²C status register (address 00F816) and hold the
SCL at the HIGH.
➃ Set a communication enable status by setting “4816” in the I²C
control register (address 00F916).
➄ Set the address data of the destination of transmission in the high-
order 7 bits of the I²C data shift register (address 00F616) and set
“0” in the least significant bit.
➅ Set “F016” in the I²C status register (address 00F816) to generate
a START condition. At this time, an SCL for 1 byte and an ACK
clock automatically occurs.
➆ Set transmit data in the I²C data shift register (address 00F616). At
this time, an SCL and an ACK clock automatically occurs.
➇ When transmitting control data of more than 1 byte, repeat step ➆.
➈ Set “D016” in the I²C status register (address 00F816). After this, if
ACK is not returned or transmission ends, a STOP condition will
be generated.
8.6.11 Example of Slave Reception
An example of slave reception in the high-speed clock mode, at the
SCL frequency of 400 kHz, in the ACK non-return mode, using the
addressing format, is shown below.
➀ Set a slave address in the high-order 7 bits of the I²C address
register (address 00F716) and “0” in the RBW bit.
➁ Set the no ACK clock mode and SCL = 400 kHz by setting “2516” in
the I²C clock control register (address 00FA16).
➂ Set “1016” in the I²C status register (address 00F816) and hold the
SCL at the HIGH.
➃ Set a communication enable status by setting “4816” in the I²C
control register (address 00F916).
➄ When a START condition is received, an address comparison is
made.
➅ •When all transmitted address are“0” (general call):
AD0 of the I²C status register (address 00F816) is set to “1”and
an interrupt request signal occurs.
•When the transmitted addresses match the address set in ➀:
ASS of the I²C status register (address 00F816) is set to “1” and
an interrupt request signal occurs.
•In the cases other than the above:
AD0 and AAS of the I²C status register (address 00F816) are set
to “0” and no interrupt request signal occurs.
➆ Set dummy data in the I²C data shift register (address 00F616).
➇ When receiving control data of more than 1 byte, repeat step ➆.
➈ When a STOP condition is detected, the communication ends.
Rev.1.01 2003.07.16 page 43 of 170