M37281EKSP Datasheet, PDF (22/172 Pages) Renesas Technology Corp – SINGLE-CHIP 8-BIT CMOS MICROCOMPUTER with CLOSED CAPTION DECODER and ON-SCREEN DISPLAY CONTROLLER

M37281MAH–XXXSP,M37281MFH–XXXSP,M37281MKH–XXXSP, M37281EKSP
(4) Serial I/O Interrupt
This is an interrupt request from the clock synchronous serial I/O
function.
(5) f(XIN)/4096 • SPRITE OSD Interrupt
The f (XIN)/4096 interrupt occurs regularly with a f(XIN)/4096 pe-
riod. Set bit 0 of the PWM mode register 1 to “0.”
The SPRITE OSD interrupt occurs at the completion of SPRITE
display.
Since f(XIN)/4096 interrupt and SPRITE OSD interrupt share the
same vector, an interrupt source is selected by bit 5 of the SPRITE
OSD control register (address 025816).
(6) Data Slicer Interrupt
An interrupt occurs when slicing data is completed.
(7) Multi-master I²C-BUS Interface Interrupt
This is an interrupt request related to the multi-master I²C-BUS
interface.
(8) A-D Conversion • INT3 external Interrupt
The A-D conversion interrupt occurs at the completion of A-D
conversion.
The INT3 is an external input,the system detects that the level of
a pin changes from LOW to HIGH or from HIGH to LOW, and
generates an interrupt request. The input active edge can be
selected by bit 6 of the interrupt input polarity register (address
021216) : when this bit is “0,” a change from LOW to HIGH is
detected; when it is “1,” a change from HIGH to LOW is detected.
Note that this bit is cleared to “0” at reset.
Since A-D conversion interrupt and the INT3 external interrupt
share the same vector, an interrupt source is selected by bit 7 of
the interrupt interval determination control register (address
021216).
(9) Timer 5 • 6 Interrupt
An interrupt is generated by an overflow of timer 5 or 6. Their
priorities are same, and can be switched by software.
(10) BRK Instruction Interrupt
This software interrupt has the least significant priority. It does
not have a corresponding interrupt enable bit, and it is not af-
fected by the interrupt disable flag I (non-maskable).
Interrupt request bit
Interrupt enable bit
Interrupt disable flag I
BRK instruction
Reset
Fig. 8.3.1 Interrupt Control
Interrupt
request
Rev.1.01 2003.07.16 page 22 of 170