4513_03 Datasheet, PDF (37/210 Pages) Renesas Technology Corp – 4-BIT SINGLE-CHIP MICROCOMPUTER

HARDWARE
FUNCTION BLOCK OPERATIONS
(6) Interrupt control registers
• Interrupt control register V1
Interrupt enable bits of external 0, external 1, timer 1 and timer 2
are assigned to register V1. Set the contents of this register
through register A with the TV1A instruction. The TAV1 instruction
can be used to transfer the contents of register V1 to register A.
• Interrupt control register V2
Interrupt enable bits of timer 3, timer 4, A-D and serial I/O are as-
signed to register V2. Set the contents of this register through
register A with the TV2A instruction. The TAV2 instruction can be
used to transfer the contents of register V2 to register A.
Table 6 Interrupt control registers
Interrupt control register V1
V13
Timer 2 interrupt enable bit
V12
Timer 1 interrupt enable bit
V11
External 1 interrupt enable bit
V10
External 0 interrupt enable bit
at reset : 00002
at RAM back-up : 00002
0
Interrupt disabled (SNZT2 instruction is valid)
1
Interrupt enabled (SNZT2 instruction is invalid)
0
Interrupt disabled (SNZT1 instruction is valid)
1
Interrupt enabled (SNZT1 instruction is invalid)
0
Interrupt disabled (SNZ1 instruction is valid)
1
Interrupt enabled (SNZ1 instruction is invalid)
0
Interrupt disabled (SNZ0 instruction is valid)
1
Interrupt enabled (SNZ0 instruction is invalid)
Interrupt control register V2
at reset : 00002
at RAM back-up : 00002
0
V23 Serial I/O interrupt enable bit
1
0
V22 A-D interrupt enable bit
1
0
V21 Timer 4 interrupt enable bit
1
0
V20 Timer 3 interrupt enable bit
1
Note: “R” represents read enabled, and “W” represents write enabled.
Interrupt disabled (SNZSI instruction is valid)
Interrupt enabled (SNZSI instruction is invalid)
Interrupt disabled (SNZAD instruction is valid)
Interrupt enabled (SNZAD instruction is invalid)
Interrupt disabled (SNZT4 instruction is valid)
Interrupt enabled (SNZT4 instruction is invalid)
Interrupt disabled (SNZT3 instruction is valid)
Interrupt enabled (SNZT3 instruction is invalid)
R/W
R/W
1-24
4513/4514 Group User’s Manual