4513_03 Datasheet, PDF (203/210 Pages) Renesas Technology Corp – 4-BIT SINGLE-CHIP MICROCOMPUTER

APPENDIX
3.6 Mark specification form
3.6 Mark specification form
32P4B (32-PIN SHRINK DIP) MARK SPECIFICATION FORM
Mitsubishi IC catalog name
Please choose one of the marking types below (A, B, C), and enter the Mitsubishi IC catalog name and the special mark (if needed).
A. Standard Mitsubishi Mark
32
17
Mitsubishi lot number
(6-digit or 7-digit)
Mitsubishi IC catalog name
1
16
B. Customer’s Parts Number + Mitsubishi catalog name
32
17
Mitsubishi lot number
(6-digit or 7-digit)
Customer’s Parts Number
Note : The fonts and size of characters
are standard Mitsubishi type.
Mitsubishi IC catalog name
1
16
Note1 : The mark field should be written right aligned.
2 : The fonts and size of characters are standard Mitsubishi type.
. ^, 3 : Customer’s Parts Number can be up to 16 characters : Only 0 ~ 9, A ~ Z, +, –, /, (, ), &, ©, (periods), and (commas) are usable.
4 : If the Mitsubishi logo is not required, check the box on the right.
Mitsubishi logo is not required
C. Special Mark Required
32
17
1
16
Note1 : If the Special Mark is to be Printed, indicate the desired layout of the mark in the upper figure. The layout will be duplicated as
close as possible. Mitsubishi lot number (6-digit or 7-digit) and Mask ROM number (3-digit) are always marked.
2 : If the customer’s trade mark logo must be used in the Special Mark, check the
box on the right. Please submit a clean original of the logo. For the new special
Special logo required
character fonts a clean font original (ideally logo drawing) must be submitted.
3 : The standard Mitsubishi font is used for all characters except for a logo.
3-36
4513/4514 Group User’s Manual