GR442QR7LB102KW01L Datasheet, PDF (145/237 Pages) Murata Manufacturing Co., Ltd. – chip monolithic ceramic capacitors

!Note • Please read rating and !CAUTION (for storage, operating, rating, soldering, mounting and handling) in this catalog to prevent smoking and/or burning, etc.
• This catalog has only typical specifications. Therefore, please approve our product specifications or transact the approval sheet for product specifications before ordering.
Continued from the preceding page.
6. Electrical Test on Printed Circuit Board
1. Confirm position of the support pin or specific jig, when
inspecting the electrical performance of a capacitor after
mounting on the printed circuit board.
1-1. Avoid bending the printed circuit board by the
pressure of a test pin, etc.
The thrusting force of the test probe can flex the PCB,
resulting in cracked chips or open solder joints.
Provide support pins on the back side of the PCB to
prevent warping or flexing.
1-2. Avoid vibration of the board by shock when a test pin
contacts a printed circuit board.
[Not Recommended]
[Recommended]
C02E.pdf
Oct.1,2012
!Caution
Peeling
Test-pin
Support Pin
Test-pin
7. Printed Circuit Board Cropping
1. After mounting a capacitor on a printed circuit board, do
not apply any stress to the capacitor that is caused by
bending or twisting the board.
1-1. In cropping the board, the stress as shown at right
may cause the capacitor to crack.
Try not to apply this type of stress to a capacitor.
[Bending]
[Twisting]
2. Ascertain of the cropping method for the printed circuit
board in advance.
2-1. Printed circuit board cropping shall be carried out by
using a jig or an apparatus to prevent the mechanical
stress that can occur to the board.
(1) Example of a suitable jig
Recommended example: the board should be
pushed as close to the cropping jig as possible
and from the back side of board in order to
minimize the compressive stress applied to the
capacitor.
Not recommended example: when the board is
pushed at a point far from the cropping jig and
from the front side of board as below, the
capacitor may form a crack caused by the tensile
stress applied to capacitor.
Printed Circuit Board
Recommended
Direction of Load
Components
Load Point
[Outline of Jig]
Printed Circuit Board
V-groove
Board Cropping Jig
Not recommended
Load Point
Direction of Load
Printed Circuit Board
Components
Continued on the following page.
127