PIC16LF1526 Datasheet, PDF (98/354 Pages) Microchip Technology – 64-Pin Flash Microcontrollers with nanoWatt XLP Technology

PIC16(L)F1526/27
10.1 Independent Clock Source
10.3 Time-Out Period
The WDT derives its time base from the 31 kHz
LFINTOSC internal oscillator. Time intervals in this
chapter are based on a nominal interval of 1ms. See
Section 25.0 “Electrical Specifications” for the
LFINTOSC tolerances.
The WDTPS bits of the WDTCON register set the
time-out period from 1ms to 256 seconds (nominal).
After a Reset, the default time-out period is 2 seconds.
10.4 Clearing the WDT
10.2 WDT Operating Modes
The Watchdog Timer module has four operating modes
controlled by the WDTE<1:0> bits in Configuration
Word 1. See Table 10-1.
10.2.1 WDT IS ALWAYS ON
When the WDTE bits of Configuration Word 1 are set to
‘11’, the WDT is always on.
WDT protection is active during Sleep.
10.2.2 WDT IS OFF IN SLEEP
When the WDTE bits of Configuration Word 1 are set to
‘10’, the WDT is on, except in Sleep.
WDT protection is not active during Sleep.
10.2.3 WDT CONTROLLED BY SOFTWARE
When the WDTE bits of Configuration Word 1 are set to
‘01’, the WDT is controlled by the SWDTEN bit of the
WDTCON register.
WDT protection is unchanged by Sleep. See
Table 10-1 for more details.
TABLE 10-1: WDT OPERATING MODES
WDTE<1:0>
SWDTEN
Device
Mode
WDT
Mode
11
X
X
Active
The WDT is cleared when any of the following condi-
tions occur:
• Any Reset
• CLRWDT instruction is executed
• Device enters Sleep
• Device wakes up from Sleep
• Oscillator fail event
• WDT is disabled
• OST is running
See Table 10-2 for more information.
10.5 Operation During Sleep
When the device enters Sleep, the WDT is cleared. If
the WDT is enabled during Sleep, the WDT resumes
counting.
When the device exits Sleep, the WDT is cleared
again. The WDT remains clear until the OST, if
enabled, completes. See Section 5.0 “Oscillator
Module (With Fail-Safe Clock Monitor)” for more
information on the OST.
When a WDT time-out occurs while the device is in
Sleep, no Reset is generated. Instead, the device
wakes up and resumes operation. The TO and PD bits
in the STATUS register are changed to indicate the
event. See Section 3.0 “Memory Organization” and
The STATUS register (Register 3-1) for more
information.
Awake Active
10
X
Sleep Disabled
1
Active
01
X
0
Disabled
00
X
X Disabled
TABLE 10-2: WDT CLEARING CONDITIONS
Conditions
WDTE<1:0> = 00
WDTE<1:0> = 01 and SWDTEN = 0
WDTE<1:0> = 10 and enter Sleep
CLRWDT Command
Oscillator Fail Detected
Exit Sleep + System Clock = SOSC, EXTRC, INTOSC, EXTCLK
Exit Sleep + System Clock = XT, HS, LP
Change INTOSC divider (IRCF bits)
WDT
Cleared
Cleared until the end of OST
Unaffected
DS41458A-page 98
Preliminary
 2011 Microchip Technology Inc.