1EDI2002AS_15 Datasheet, PDF (134/147 Pages) Infineon Technologies AG – Single Channel Isolated Driver for Inverter Systems AD Step

5.5.3 Primary I/O Electrical Characteristics
EiceDRIVER™ SIL
1EDI2002AS
Specification
Table 5-7 Electrical Characteristics for Pins: INP, INSTP, EN/FEN
Parameter
Symbol
Values
Unit Note / Test Condition
Min.
Typ.
Max.
Low Input Voltage
High Input Voltage
Weak pull down resistance INP,
INSTP, EN/FEN
V_INPRL1
V_INPRH1
R_PDIN1
0
-
0.7xV_CC1 -
20
-
0.3xV_CC1 V
V_CC1
V
100
kΩ
Referenced to REF0
Referenced to REF0
To REF0
Input Current
|I_INPR1| -
Input Pulse Suppression
t_INPS1
-
Time between EN/FEN valid and INP t_INPEN 8
High Level
-
300
μA
20
-
ns
-
-
µs
INP High / Low Duration
t_INPPD
250
-
-
ns
INSTP High / Low Duration
t_INSTPPD 250
-
-
ns
Duration between EN/FEN valid-to- t_ENINV 8
-
-
µs
invalid transition and the next invalid-
to-valid transition
1) Not subject to production test. This parameter is verified by design / characterization.
1)
See Chapter 2.4.3
1)
1)
1)
Table 5-8 Electrical Characteristics for Pins: NRST/RDY, SCLK, SDI, NCS, DIO1 (input)
Parameter
Symbol
Values
Unit Note / Test Condition
Min.
Typ.
Max.
Low Input Voltage
High Input Voltage
Weak pull up resistance to SCLK,
SDI, NCS
V_INPL1
V_INPH1
R_PUSPI1
0
-
0.7xV_CC1 -
26.5
-
0.3xV_CC1 V
V_CC1
V
100
kΩ
Referenced to GND1
Referenced to GND1
To VCC1.
Weak pull down resistance on DIO1 R_PDDIO1 26.5
-
100
Input Current
|I_INP1|
-
-
400
NRST/RDY Output Voltage in Non- V_OUTNR -
Ready conditions.
-
-
1
0.7
1
NRST/RDY driven-active time after t_RST
-
power supplies are within operating
range.
15.4
-
kΩ To GND1,
μA
V
V_cc1=5V, I_load = 2 mA
V V_cc1=0V, I_load = 500 µA
µs ¹⁾
NRST/RDY minimum activation time. t_RSTAT 10
-
-
µs
1) Not subject to production test. This parameter is verified by design / characterization.
Datasheet
134
Hardware Description
Rev. 3.1, 2015-07-30