MC68340FE16E Datasheet, PDF (389/441 Pages) Freescale Semiconductor, Inc – Integrated Processor with DMA User’s Manual

Freescale Semiconductor, Inc.
XTAL
MC68340
EXTAL
330 k
20 M
4.7 pF
32.768 kHz
10 pF
Figure 10-2. Sample Crystal Circuit
The circuit shown in Figure 10-3 is the typical circuit recommended by Statek Corporation,
for 32768 kHz crystal, part number CX-IV. It is recommended to start with these values,
but parameter values may need to be adjusted to compensate for variables in layout.
XTAL
MC68340
EXTAL
470 k
22 M
10 pF
32.768 kHz
20 pF
Figure 10-3. Statek Corporation Crystal Circuit
A separate power pin (V_CCSYN) is used to allow the clock circuits to operate with the rest
of the device powered down and to provide increased noise immunity for the clock circuits.
The source for V_CCSYN should be a quiet power supply, and external bypass capacitors
(see Figure 10-4) should be placed as close as possible to the V_CCSYN pin to ensure a
stable operating frequency.
Additionally, the PLL requires that an external low-leakage filter capacitor, typically in the
range of 0.01 to 0.1 µF, be connected between the XFC and V_CCSYN pins. The XFC
capacitor should provide 50-MΩ insulation but should not be electrolytic. For external
clock mode without PLL, the XFC pin can be left open. Smaller values of the external filter
capacitor provide a faster response time for the PLL, and larger values provide greater
frequency stability. Figure 10-4 depicts examples of both an external filter capacitor and
bypass capacitors for V_CCSYN.
10-2
MC68340 USER’S MANUAL
MOTOROLA
For More Information On This Product,
Go to: www.freescale.com