MC68HC908LJ12 Datasheet, PDF (182/413 Pages) Freescale Semiconductor, Inc – 8-bit microcontroller units

Monitor ROM (MON)
10.6.8 EE_READ
EE_READ is used to load the data array in RAM with a set of data from
FLASH.
Table 10-18. EE_READ Routine
Routine Name
EE_READ
Routine Description
Emulated EEPROM read. Data size ranges from 2 to 15
bytes at a time.
Calling Address
$FC03
Stack Used
15 bytes
Data Block Format
Bus speed (BUS_SPD)
Data size (DATASIZE)
Starting address (ADDRH)⁽¹⁾
Starting address (ADDRL)⁽¹⁾
Data 1
:
Data N
Notes:
1. The start address must be a page boundary start address, e.g. $xx00 or $xx80.
The EE_READ routine reads data stored by the EE_WRITE routine. An
EE_READ call will retrieve the last data written to a FLASH page and
loaded into the data array in RAM. Same as EE_WRITE, the data size
indicated by DATASIZE is 2 to 15, and the start address
ADDRH:ADDRL must the FLASH page boundary address.
The coding example below uses the data stored by the EE_WRITE
coding example (see 10.6.7 EE_WRITE). It loads the 15-byte data set
stored in the $EF00–$EE7F page to the data array in RAM. The
initialization subroutine is the same as the coding example for
EE_WRITE (see 10.6.7 EE_WRITE).
EE_READ
EQU
$FC03
MAIN:
BSR
:
:
LDHX
JSR
:
INITIALIZATION
FILE_PTR
EE_READ
MC68HC908LJ12 — Rev. 2.1
Freescale Semiconductor
Monitor ROM (MON)
Technical Data
183