English
Language : 

BCM4354KKWBGT Datasheet, PDF (134/192 Pages) Cypress Semiconductor – Single-Chip 5G Wi-Fi IEEE 802.11ac 2×2 MAC/ Baseband/Radio with Integrated Bluetooth 4.1 and FM Receiver
BCM4354 Data Sheet
Bluetooth RF Specifications
Table 34: Bluetooth Transmitter RF Specifications (Cont.)
Parameter
Conditions
Minimum Typical Maximum Unit
GFSK In-Band Spurious Emissions
–20 dBc BW
–
–
EDR In-Band Spurious Emissions
1.0 MHz < |M – N| < 1.5 MHz
1.5 MHz < |M – N| < 2.5 MHz
|M – N|  2.5 MHza
M – N = the frequency range for –
which the spurious emission is
measured relative to the
–
transmit center frequency.
–
Out-of-Band Spurious Emissions
30 MHz to 1 GHz
–
–
1 GHz to 12.75 GHz
–
–
1.8 GHz to 1.9 GHz
–
–
5.15 GHz to 5.3 GHz
–
–
GPS Band Spurious Emissions
Spurious emissions
–
–
0.93 1
–38 –26.0
–31 –20.0
–43 –40.0
MHz
dBc
dBm
dBm
–
–36.0 b,c dBm
–
–30.0 b,d,e dBm
–
–47.0
dBm
–
–47.0
dBm
–103 –
dBm
Out-of-Band Noise Floorf
65–108 MHz
776–794 MHz
869–960 MHz
925–960 MHz
1570–1580 MHz
1805–1880 MHz
FM RX
CDMA2000
cdmaOne, GSM850
E-GSM
GPS
GSM1800
–
–147 –
–
–147 –
–
–147 –
–
–147 –
–
–146 –
–
–145 –
dBm/Hz
dBm/Hz
dBm/Hz
dBm/Hz
dBm/Hz
dBm/Hz
1930–1990 MHz
GSM1900, cdmaOne, WCDMA –
–144 –
dBm/Hz
2110–2170 MHz
2500–2570 MHz
2300–2400 MHz
2570–2620 MHz
2545–2575 MHz
WCDMA
Band 7
Band 40
Band 38
XGP Band
–
–141 –
–
–140 –
–
–140 –
–
–140 –
–
–140 –
dBm/Hz
dBm
dBm
dBm
dBm
a. The typical number is measured at ± 3 MHz offset.
b. The maximum value represents the value required for Bluetooth qualification as defined in the v4.1 specification.
c. The spurious emissions during Idle mode are the same as specified in Table 34 on page 132.
d. Specified at the Bluetooth Antenna port.
e. Meets this specification using a front–end band–pass filter.
f. Transmitted power in cellular and FM bands at the Bluetooth Antenna port. See Figure 35 on page 129 for
location of the port.
Broadcom®
October 15, 2014 • 4354-DS109-R
BROADCOM CONFIDENTIAL
Page 133