BCM4354KKWBGT Datasheet, PDF (130/192 Pages) Cypress Semiconductor – Single-Chip 5G Wi-Fi IEEE 802.11ac 2×2 MAC/ Baseband/Radio with Integrated Bluetooth 4.1 and FM Receiver

BCM4354 Data Sheet
Bluetooth RF Specifications
Section 15: Bluetooth RF Specifications
Note: Values in this data sheet are design goals and are subject to change based on the results of
device characterization.
Unless otherwise stated, limit values apply for the conditions specified in Table 30: “Environmental Ratings,” on
page 126 and Table 32: “Recommended Operating Conditions and DC Characteristics,” on page 127. Typical
values apply for an ambient temperature of +25°C.
Figure 35: RF Port Location for Bluetooth Testing
BCM4354
WLAN Tx
BT Tx
WLAN/BT Rx
RF Switch
(0.5 dB Insertion Loss)
Filter
Antenna
Port
Chip
RF Port
Port
Note: All Bluetooth specifications are measured at the chip port unless otherwise specified.
Table 33: Bluetooth Receiver RF Specifications
Parameter
Conditions
Minimum Typical Maximum Unit
Note: The specifications in this table are measured at the chip port output unless otherwise specified.
General
Frequency range
RX sensitivity
–
GFSK, 0.1% BER, 1 Mbps
/4–DQPSK, 0.01% BER,
2 Mbps
2402
–
–
–
–93.5
–95.5
2480
–
–
MHz
dBm
dBm
8–DPSK, 0.01% BER,
–
3 Mbps
–89.5
–
dBm
Input IP3
–
–16
–
–
dBm
Maximum input at antenna –
–
–
–20
dBm
Broadcom^®
October 15, 2014 • 4354-DS109-R
BROADCOM CONFIDENTIAL
Page 129