W83791G Datasheet, PDF (70/99 Pages) Winbond – Winbond H/W Monitoring IC

W83791D/G
BEEP Control Register 3 ⎯ Index A3h (Bank 0) , continued
BIT
NAME
ATTRIBUTE
DESCRIPTION
2 EN_TART1_BP R/W
Enable BEEP output from Target temperature 1. Write 1;
enable BEEP output. Set 0 (default value), it will be disable
BEEP tone output.
1 EN_VBAT_BP R/W
Enable BEEP output from V-Core B. Write 1; enable BEEP
output, which is default value.
0 EN_VSB_BP R/W
Enable BEEP Output from V-Core A if the monitor value
exceeds the limits value. Write 1, enable BEEP output, which
is default value.
7.86 Speech Flash Memory Read Data Registers ⎯ Index A4h-A5h (Bank 0)
Power on default: 00h
INDEX
NAME
ATTRIBUTE
DESCRIPTION
A4h
SPEECHRD2 _RO
A5h
SPEECHRD3 RO
Speech Flash Read Data 2. Speech flash reading data
bits [23:16].
Speech Flash Read Data 3. Speech flash reading data
bits [31:24].
7.87 EVNTRAP1- 5 and GPIO 5-9 Select ⎯ Index A6h (Bank 0)
Power on default: 00h
BIT
NAME
7 ^GPIO_SEL
ATTRIBUTE
R/W
6 SMI_LEDOUT R/W
5 Reserved
Reserved
4 EVNT5_GPIO9 R/W
3 EVNT4_GPIO8 R/W
2 EVNT3_GPIO7 R/W
1 EVNT2_GPIO6 R/W
0 EVNT1_GPIO5 R/W
DESCRIPTION
Write ‘1’ to this bit then read it, if return ‘0’ means speech
function else means GPIO function.
Select SMI# or LEDOUT function at pin 44. Default is SMI#
function.
Write ‘1’ select to pin 1 as GPIO9 function when using
speech. Default is ‘0’. Note: Index 15h bit6=’0’ if use GPIO
function at this pin.
Write ‘1’ select to pin 48 as GPIO8 function when using
speech. Default is ‘0’. Note: Index 15h bit6=’0’ if use GPIO
function at this pin.
Write ‘1’ select to pin 47 as GPIO7 function when using
speech. Default is ‘0’. Note: Index 15h bit6=’0’ if use GPIO
function at this pin.
Write ‘1’ select to pin 46 as GPIO6 function when using
speech. Default is ‘0’. Note: Index 15h bit6=’0’ if use GPIO
function at this pin.
Write ‘1’ select to pin 45 as GPIO5 function when using
speech. Default is ‘0’.
- 64 -
Publication Release Date: April 14, 2006
Revision 1.1