W29N02GVSIAA Datasheet, PDF (49/79 Pages) Winbond – W29N02GV 2G-BIT 3.3V NAND FLASH MEMORY

W29N02GV
9.6.1 GET FEATURES (EEh)
The GET FEATURES command returns the device feature settings including those previously set by
the SET FEATURES command. To use the Get Feature mode write the command (EEh) to the
Command Register followed by the single cycle byte Feature Address. RY/#BY will goes LOW for the
period of tFEAT. If Read Status (70h) command is issued for monitoring the process completion
status, Read Command (00h) has to be executed to re-establish data output mode. Once, RY/#BY
goes HIGH, the device feature settings can be read by toggling #RE. The device remains in Feature
Mode until another valid command is issued to Command Register. See Figure 9-27.
CLE
#CE
#WE
ALE
#RE
I/Ox
RY/#BY
EEh
FA
P1
P2
P3
P4
Feature address
1 cycle
tFEAT
Figure 9-26 Get Feature Operation
Release Date: February 1^st, 2016
49
– Revision B