LM3S6C11 Datasheet, PDF (791/828 Pages) Texas Instruments – Stellaris® LM3S6C11 Microcontroller

OBSOLETE: TI has discontinued production of this device.
Stellaris^® LM3S6C11 Microcontroller
Table 20-33. Analog Comparator Voltage Reference Characteristics
Parameter
R_HR
R_LR
A_HR
A_LR
Parameter Name
Resolution in high range
Resolution in low range
Absolute accuracy high range
Absolute accuracy low range
Min
Nom
-
V_DDA/31
-
V_DDA/23
-
-
-
-
Max
-
-
±R_HR/2
±R_LR/4
Unit
V
V
V
V
20.17
20.17.1
Current Consumption
This section provides information on typical and maximum power consumption under various
conditions. Unless otherwise indicated, current consumption numbers include use of the on-chip
LDO regulator and therefore include I_DDC.
Nominal Power Consumption
The following table provides nominal figures for current consumption.
Table 20-34. Nominal Power Consumption
Parameter
I_{DD_RUN}
Parameter Name
Run mode 1 (Flash loop)
Conditions
V_DD = 3.3 V
Code= while(1){} executed out of Flash
Nom
101^a
159^b
Unit
mA
Peripherals = All ON
System Clock = 80 MHz (with PLL)
Temp = 25°C
I_{DD_SLEEP} Sleep mode
V_DD = 3.3 V
Peripherals = All clock gated
20
mA
System Clock = 80 MHz (with PLL)
Temp = 25°C
I_{DD_DEEPSLEEP} Deep-sleep mode
Peripherals = All OFF
System Clock = IOSC30KHZ/64
Temp = 25°C
550
µA
I_{HIB_NORTC}
Hibernate mode (external wake, V_BAT = 3.0 V
RTC disabled, I/O not
powered^c)
V_DD = 0 V
V_DDA = 0 V
Peripherals = All OFF
30
µA
System Clock = OFF
Hibernate Module = 0 kHz
I_{HIB_RTC}
Hibernate mode (RTC enabled,
I/O not powered^c)
V_BAT = 3.0 V
V_DD = 0 V
V_DDA = 0 V
Peripherals = All OFF
44
µA
System Clock = OFF
Hibernate Module = 32 kHz
a. Ethernet MAC and PHY powered down by software.
b. Auto-negotiate enabled. If an Ethernet cable is attached to the connector, the consumption increases by 7-10 mA.
c. The VDD3ON mode must be disabled for the I/O ring to be unpowered.
July 24, 2012
791
Texas Instruments-Production Data