LM3S6C11 Datasheet, PDF (401/828 Pages) Texas Instruments – Stellaris® LM3S6C11 Microcontroller

OBSOLETE: TI has discontinued production of this device.
Stellaris^® LM3S6C11 Microcontroller
Table 9-5. GPIO Interrupt Configuration Example (continued)
Register
Desired Interrupt ^{Pin 2 Bit Valuea}
Event Trigger
7
6
5
4
GPIOIEV
0=Low level, or falling X
X
X
X
edge
1=High level, or rising
edge
GPIOIM
0=masked
0
0
0
0
1=not masked
a. X=Ignored (don’t care bit)
3
X
0
2
1
1
1
X
0
0
X
0
9.4 Register Map
Table 9-7 on page 402 lists the GPIO registers. Each GPIO port can be accessed through one of
two bus apertures. The legacy aperture, the Advanced Peripheral Bus (APB), is backwards-compatible
with previous Stellaris parts. The other aperture, the Advanced High-Performance Bus (AHB), offers
the same register map but provides better back-to-back access performance than the APB bus.
Important: The GPIO registers in this chapter are duplicated in each GPIO block; however,
depending on the block, all eight bits may not be connected to a GPIO pad. In those
cases, writing to unconnected bits has no effect, and reading unconnected bits returns
no meaningful data.
The offset listed is a hexadecimal increment to the register’s address, relative to that GPIO port’s
base address:
■ GPIO Port A (APB): 0x4000.4000
■ GPIO Port A (AHB): 0x4005.8000
■ GPIO Port B (APB): 0x4000.5000
■ GPIO Port B (AHB): 0x4005.9000
■ GPIO Port C (APB): 0x4000.6000
■ GPIO Port C (AHB): 0x4005.A000
■ GPIO Port D (APB): 0x4000.7000
■ GPIO Port D (AHB): 0x4005.B000
■ GPIO Port E (APB): 0x4002.4000
■ GPIO Port E (AHB): 0x4005.C000
■ GPIO Port F (APB): 0x4002.5000
■ GPIO Port F (AHB): 0x4005.D000
■ GPIO Port G (APB): 0x4002.6000
■ GPIO Port G (AHB): 0x4005.E000
Note that each GPIO module clock must be enabled before the registers can be programmed (see
page 248). There must be a delay of 3 system clocks after the GPIO module clock is enabled before
any GPIO module registers are accessed.
Important: All GPIO pins are configured as GPIOs and tri-stated by default (GPIOAFSEL=0,
GPIODEN=0, GPIOPDR=0, GPIOPUR=0, and GPIOPCTL=0, with the exception of the
pins shown in the table below. A Power-On-Reset (POR) or asserting RST puts the pins
back to their default state.
July 24, 2012
401
Texas Instruments-Production Data