LM3S6C11 Datasheet, PDF (26/828 Pages) Texas Instruments – Stellaris® LM3S6C11 Microcontroller

Revision History
OBSOLETE: TI has discontinued production of this device.
Revision History
The revision history table notes changes made between the indicated revisions of the LM3S6C11
data sheet.
Table 1. Revision History
Date
July 2012
January 2012
Revision Description
12986.2532 Marked LM3S6C11 device as OBSOLETE.
11425 ■ In System Control chapter:
– Clarified that an external LDO cannot be used.
– Added important note to write the RCC register before the RCC2 register.
■ In Hibernation chapter:
– Changed terminology from non-volatile memory to battery-backed memory.
– Numerous clarifications, including adding a section "System Implementation".
– Clarified Hibernation module register reset conditions.
■ In Internal Memory chapter, clarified programming and use of the non-volatile registers.
■ In GPIO chapter, corrected "GPIO Pins With Non-Zero Reset Values" table and added note that if
the same signal is assigned to two different GPIO port pins, the signal is assigned to the port with
the lowest letter.
■ In Timer chapter, clarified timer modes and interrupts.
■ In UART chapter, clarified interrupt behavior.
■ In SSI chapter, corrected SSIClk in the figure "Synchronous Serial Frame Format (Single Transfer)"
and clarified behavior of transmit bits in interrupt registers.
■ In I²C chapter, corrected bit and register reset values for IDLE bit in I²C Master Control/Status
(I2CMCS) register.
■ In Analog Comparators chapter, clarified internal reference programming.
■ In Signal Tables chapter, clarified VDDC and LDO pin descriptions.
■ In Electrical Characteristics chapter:
– In Maximum Ratings table, deleted parameter "Input voltage for a GPIO configured as an analog
input".
– In Recommended DC Operating Conditions table, corrected values for I_OH parameter.
– In Load Conditions figure, corrected value for C_L parameter.
– In JTAG Characteristics, table, corrected values for parameters "TCK clock Low time" and "TCK
clock High time".
– In LDO Regulator Characteristics table, added clarifying footnote to C_LDO parameter.
– In Sleep Modes AC Characteristics table, split parameter "Time to wake from interrupt" into
sleep mode and deep-sleep mode parameters.
– In SSI Characteristics table, corrected value for parameter "SSIClk cycle time".
– In Analog Comparator Characteristics table, added parameter "Input voltage range" and corrected
values for parameter "Input common mode voltage range".
26
July 24, 2012
Texas Instruments-Production Data