English
Language : 

LM3S6C11 Datasheet, PDF (37/828 Pages) Texas Instruments – Stellaris® LM3S6C11 Microcontroller
OBSOLETE: TI has discontinued production of this device.
Stellaris® LM3S6C11 Microcontroller
1.3.3.1
■ Two I2C modules
■ Two Synchronous Serial Interface modules (SSI)
The following sections provide more detail on each of these communications functions.
Ethernet Controller (see page 659)
Ethernet is a frame-based computer networking technology for local area networks (LANs). Ethernet
has been standardized as IEEE 802.3. This specification defines a number of wiring and signaling
standards for the physical layer, two means of network access at the Media Access Control
(MAC)/Data Link Layer, and a common addressing format.
The Stellaris Ethernet Controller consists of a fully integrated media access controller (MAC) and
network physical (PHY) interface and has the following features:
■ Conforms to the IEEE 802.3-2002 specification
– 10BASE-T/100BASE-TX IEEE-802.3 compliant. Requires only a dual 1:1 isolation transformer
interface to the line
– 10BASE-T/100BASE-TX ENDEC, 100BASE-TX scrambler/descrambler
– Full-featured auto-negotiation
■ Multiple operational modes
– Full- and half-duplex 100 Mbps
– Full- and half-duplex 10 Mbps
– Power-saving and power-down modes
■ Highly configurable
– Programmable MAC address
– LED activity selection
– Promiscuous mode support
– CRC error-rejection control
– User-configurable interrupts
■ Physical media manipulation
– MDI/MDI-X cross-over support through software assist
– Register-programmable transmit amplitude
– Automatic polarity correction and 10BASE-T signal reception
■ Efficient transfers using Micro Direct Memory Access Controller (µDMA)
– Separate channels for transmit and receive
July 24, 2012
37
Texas Instruments-Production Data