LM3S5652 Datasheet, PDF (668/848 Pages) Texas Instruments – Stellaris® LM3S5652 Microcontroller

Universal Serial Bus (USB) Controller
full-speed device to be used with a USB 2.0 hub. Control, bulk, isochronous, and interrupt transactions
are supported. This section describes the USB controller's actions when it is being used as a USB
Host. Configuration of IN endpoints, OUT endpoints, entry into and exit from SUSPEND mode, and
RESET are all described.
When in Host mode, IN transactions are controlled by an endpoint’s receive interface. All IN
transactions use the receive endpoint registers and all OUT endpoints use the transmit endpoint
registers for a given endpoint. As in Device mode, the FIFOs for endpoints should take into account
the maximum packet size for an endpoint.
■ Bulk. Bulk endpoints should be the size of the maximum packet (up to 64 bytes) or twice the
maximum packet size if double buffering is used (described further in the following section).
■ Interrupt. Interrupt endpoints should be the size of the maximum packet (up to 64 bytes) or twice
the maximum packet size if double buffering is used.
■ Isochronous. Isochronous endpoints are more flexible and can be up to 1023 bytes.
■ Control. It is also possible to specify a separate control endpoint to communicate with a Device.
However, in most cases the USB controller should use the dedicated control endpoint to
communicate with a Device’s endpoint 0.
17.3.2.1
Endpoints
The endpoint registers are used to control the USB endpoint interfaces which communicate with
Device(s) that are connected. The endpoints consist of a dedicated control IN endpoint, a dedicated
control OUT endpoint, three configurable OUT endpoints, and three configurable IN endpoints.
The dedicated control interface can only be used for control transactions to endpoint 0 of Devices.
These control transactions are used during enumeration or other control functions that communicate
using endpoint 0 of Devices. This control endpoint shares the first 64 bytes of the USB controller’s
FIFO RAM for IN and OUT transactions. The remaining IN and OUT interfaces can be configured
to communicate with control, bulk, interrupt, or isochronous Device endpoints.
These USB interfaces can be used to simultaneously schedule as many as three independent OUT
and three independent IN transactions to any endpoints on any Device. The IN and OUT controls
are paired in three sets of registers. However, they can be configured to communicate with different
types of endpoints and different endpoints on Devices. For example, the first pair of endpoint controls
can be split so that the OUT portion is communicating with a Device’s bulk OUT endpoint 1, while
the IN portion is communicating with a Device’s interrupt IN endpoint 2.
Before accessing any Device, whether for point-to-point communications or for communications via
a hub, the relevant USB Receive Functional Address Endpoint n (USBRXFUNCADDRn) or USB
Transmit Functional Address Endpoint n (USBTXFUNCADDRn) registers must be set for each
receive or transmit endpoint to record the address of the Device being accessed.
The USB controller also supports connections to Devices through a USB hub by providing a register
that specifies the hub address and port of each USB transfer. The FIFO address and size are
customizable and can be specified for each USB IN and OUT transfer. Customization includes
allowing one FIFO per transaction, sharing a FIFO across transactions, and allowing for
double-buffered FIFOs.
17.3.2.2
IN Transactions as a Host
IN transactions are handled in a similar manner to the way in which OUT transactions are handled
when the USB controller is in Device mode except that the transaction first must be initiated by
setting the REQPKT bit in the USBCSRL0 register, indicating to the transaction scheduler that there
668
November 17, 2011
Texas Instruments-Production Data