TLK3104SA_09 Datasheet, PDF (26/43 Pages) Texas Instruments – QUAD 3.125 Dbps SERIAL TRANSCEIVER

TLK3104SA
QUAD 3.125 Gbps SERIAL TRANSCEIVER
SCAS651B-− AUGUST 2000 − REVISED SEPTEMBER 2001
Table 20. Channel Status Registers (Register 22)
BIT(s)
22.15
22.14
22.13
22.12
22.11
22.10
22.9
22.8
22.7
22.6
22.5
22.4
22.3
22.2
22.1
22.0
NAME
DESCRIPTION
Channel D transmit FIFO collision error 1 = Collision error is detected to cause the transmit FIFO self reset.
0 = No error. (default)
After being read, this bit is reset to zero.
Channel C transmit FIFO collision error 1 = Collision error is detected to cause the transmit FIFO self reset.
0 = No error. (default)
After being read, this bit is reset to zero.
Channel B transmit FIFO collision error 1 = Collision error is detected to cause the transmit FIFO self reset.
0 = No error. (default)
After being read, this bit is reset to zero.
Channel A transmit FIFO collision error 1 = Collision error is detected to cause the transmit FIFO self reset.
0 = No error. (default)
After being read, this bit is reset to zero.
Channel D decode error
1 = code word or running disparity error detected.
0 = No error. (default)
After being read, this bit is reset to zero.
Channel C decode error
1 = code word or running disparity error detected.
0 = No error. (default)
After being read, this bit is reset to zero.
Channel B decode error
1 = code word or running disparity error detected.
0 = No error. (default)
After being read, this bit is reset to zero.
Channel A decode error
1 = code word or running disparity error detected.
0 = No error. (default)
After being read, this bit is reset to zero.
Channel D PRBS pass
1 = PRBS testing passes without error (default).
0 = Error is detected during PRBS test.
After being read, this bit is reset to one.
Channel C PRBS pass
1 = PRBS testing passes without error (default).
0 = Error is detected during PRBS test
After being read, this bit is reset to one.
Channel B PRBS pass
1 = PRBS testing passes without error (default).
0 = Error is detected during PRBS test
After being read, this bit is reset to one.
Channel A PRBS pass
1 = PRBS testing passes without error (default).
0 = Error is detected during PRBS test
After being read, this bit is reset to one.
Channel D LOS output
1 = LOS condition is reported.
0 = No LOS. (default)
After being read, this bit is reset to zero.
Channel C LOS output
1 = LOS condition is reported.
0 = No LOS. (default)
After being read, this bit is reset to zero.
Channel B LOS output
1 = LOS condition is reported.
0 = No LOS. (default)
After being read, this bit is reset to zero.
Channel A LOS output
1 = LOS condition is reported.
0 = No LOS. (default)
After being read, this bit is reset to zero.
READ/WRITE
Read only
Read only
Read only
Read only
Read only
Read only
Read only
Read only
Read only
Read only
Read only
Read only
Read only
Read only
Read only
Read only
26
• POST OFFICE BOX 655303 DALLAS, TEXAS 75265