CC2510FX Datasheet, PDF (21/244 Pages) List of Unclassifed Manufacturers – True System-on-Chip with Low Power RF Transceiver and 8051 MCU

C2510Fx / CC2511Fx
Parameter
Single ended input
(-THD+N)
SINAD⁴
Differential input
(-THD+N)
Conversion time
Current consumption
Min Typ Max Unit Condition/Note
46.8
dB 9-bits setting
57.5
dB 10-bits setting
66.6
dB 12-bits setting
40.7
dB 7-bits setting
51.6
dB 9-bits setting
61.8
dB 10-bits setting
70.8
dB 12-bits setting
20
µs 7-bits setting
36
µs 9-bits setting
68
µs 10-bits setting
132
µs 12-bits setting
1.2
mA
Table 18: 7-12 bit ADC Characteristics
7.11 Control AC Characteristics
T_A = 25 °C, VDD = 3.0 V if nothing else stated. All measurement results are obtained using the
CC2510EM reference designs ([1]).
Parameter
Min Typ Max Unit Condition/Note
System clock,
f_SYSCLK
CC2510Fx
t_SYSCLK= 1/ f_SYSCLK
0.1875 26
27
MHz High speed crystal oscillator used as source (HS XOSC)
RESET_N low
width
Interrupt pulse
width
0.1875 13 13.5 MHz Calibrated HS RCOSC used as source.
HS
HS
XOSC RCOSC
Min: f_XOSC = 24 MHz, CLKCON.CLKSPD =
111
111
Typ: f_XOSC = 26 MHz, CLKCON.CLKSPD = ⁰⁰⁰
001
Max: f_XOSC = 27 MHz, CLKCON.CLKSPD = ⁰⁰⁰
001
CC2511Fx
0.1875 24
24
MHz High speed crystal oscillator used as source.
0.1875 12
12
HS RCOSC used as source.
Min: f_XOSC = 48 MHz, CLKCON.CLKSPD = 111
Typ and Max: f_XOSC = 48 MHz, CLKCON.CLKSPD = 000
250
ns See item 1, Figure 4. This is the shortest pulse that is
guaranteed to be recognized as a reset pin request.
Note: Shorter pulses may be recognized but will not lead to
complete reset of all modules within the chip.
t_SYSCLK
See item 2, Figure 4. This is the shortest pulse that is
guaranteed to be recognized as an interrupt request. In PM2/3
the internal synchronizers are bypassed so this requirement
does not apply in PM2/3.
Table 19: Control Inputs AC Characteristics
SWRS055D
Page 21 of 243