LSM6DB0 Datasheet, PDF (52/66 Pages) STMicroelectronics – 3D accelerometer, 3D gyroscope and signal processor

Register description
Zen_G
Yen_G
Xen_G
LIR_XL1
4D_XL1
LSM6DB0
Table 64. CTRL_REG4 register description
Gyroscope’s yaw axis (Z) output enable. Default value: 1
(0: Z-axis output disabled; 1: Z-axis output enabled)
Gyroscope’s roll axis (Y) output enable. Default value: 1
(0: Y-axis output disabled; 1: Y axis output enabled)
Gyroscope’s pitch axis (X) output enable. Default value: 1
(0: X-axis output disabled; 1: X-axis output enabled)
Latched interrupt. Default value: 0
(0: interrupt request not latched; 1: interrupt request latched)
4D option enabled on interrupt. Default value: 0
(0: interrupt generator uses 6D for position recognition; 1: interrupt generator uses
4D for position recognition)
11.26
CTRL_REG5_XL (1Fh)
Linear acceleration sensor control register 5.
Table 65. CTRL_REG5_XL register
DEC_1 DEC_0 Zen_XL Yen_XL Xen_XL
0⁽¹⁾
0⁽¹⁾
0⁽¹⁾
1. These bits must be set to ‘0’ for the correct operation of the device
DEC_ [0:1]
Table 66. CTRL_REG5_XL register description
Decimation of acceleration data on OUT REG and FIFO. Default value: 00
(00: no decimation;
01: update every 2 samples;
10: update every 4 samples;
11: update every 8 samples)
Zen_XL
Accelerometer’s Z-axis output enable. Default value: 1
(0: Z-axis output disabled; 1: Z-axis output enabled)
Yen_XL
Accelerometer’s Y-axis output enable. Default value: 1
(0: Y-axis output disabled; 1: Y-axis output enabled)
Xen_XL
Accelerometer’s X axis output enable. Default value: 1
(0: X-axis output disabled; 1: X-axis output enabled)
11.27
CTRL_REG6_XL (20h)
Linear acceleration sensor control register 6.
Table 67. CTRL_REG6_XL register
ODR_XL2 ODR_XL1 ODR_XL0 FS1_XL
FS0_XL
BW_SCAL
_ODR
BW_XL1
BW_XL0
52/66
DocID025603 Rev 1