LAN9117_08 Datasheet, PDF (136/136 Pages) SMSC Corporation – High Performance Single-Chip 10/100 Non-PCI Ethernet Controller

High Performance Single-Chip 10/100 Non-PCI Ethernet Controller
Chapter 9 Revision History
Datasheet
Table 9.1 Customer Revision History
REVISION LEVEL & DATE SECTION/FIGURE/ENTRY
CORRECTION
Rev. 1.4
(06-20-08)
Table 2.5, “System and
Added text to VDD_CORE and VDD_PLL pin
Power Signals,” on page 17 ^{descriptions that states the pins must not be used}
to supply power to external devices.
Figure 1.2 on page 11
Diagrams redone. A PLL regulator block was
added and the word “Core” was added to the
original regualtor block.
Rev. 1.4
(06-12-08)
Table 2.4, “Serial EEPROM
Interface Signals,” on
page 16
Added note to the EECLK pin: “When the
EEPROM interface is not used, the EECLK pin
must be left unconnected.”
(Per change request 737306-KL0774)
Section 3.5, "Wake-up
Frame Detection," on
page 28 and Section 5.4.1,
"MAC_CR—MAC Control
Register," on page 99
Added note: “When wake-up frame detection is
enabled via the WUEN bit of the WUCSR—Wake-
up Control and Status Register, a broadcast wake-
up frame will wake-up the device despite the state
of the Disable Broadcast Frames (BCAST) bit in
the MAC_CR—MAC Control Register.”
Section 5.4.12, "WUCSR—
Wake-up Control and Status
Register," on page 107
Fixed typo in bit 9: “... Mac Address [1:0] bit set to
0.” was changed to “...Mac Address [0] bit set to 0.”
Section 5.5.5, "Auto-
negotiation Advertisement,"
on page 112
Bits 9 and 15 relabeled as Reserved, Read-Only
(RO), with a default of 0.
Section 5.5.5, "Auto-
negotiation Advertisement,"
on page 112
Fixed definition of bits 11:10 when equal to “11” by
adding “advertise support for..” to beginning of
definition. Also added note stating “When both
symmetric PAUSE and asymmetric PAUSE
support are advertised, the device will only be
configured to, at most, one of the two settings
upon auto-negotiation completion.”
Section 7.1, "Absolute
Maximum Ratings*," on
page 129 and Section 7.2,
"Operating Conditions**," on
page 129
Removed 1.8V output voltage (VDD_PLL,
VDD_CORE) ratings and notes which stated:
“These pins must not be used to supply power to
other external devices.” These specifications are
not needed by the customer since the regulators
are not to be used for external applications.
Revision 1.5 (07-11-08)
136
DATASHEET
SMSC LAN9117