LAN9117_08 Datasheet, PDF (126/136 Pages) SMSC Corporation – High Performance Single-Chip 10/100 Non-PCI Ethernet Controller

6.7
High Performance Single-Chip 10/100 Non-PCI Ethernet Controller
TX Data FIFO Direct PIO Writes
Datasheet
In this mode the upper address inputs are not decoded, and any write to the LAN9117 will write the
TX Data FIFO. This mode is enabled when FIFO_SEL is driven high during a write access. This is
normally accomplished by connecting the FIFO_SEL signal to a high-order address line. This mode is
useful when the host processor must increment its address when accessing the LAN9117. Timing is
identical to a PIO write, and the FIFO_SEL signal has the same timing characteristics as the address
lines.
FIFO_SEL
A[2:1]
nCS, nWR
Data Bus
Figure 6.6 TX Data FIFO Direct PIO Write Timing
Note: The “Data Bus” width is 16 bits
SYMBOL
t_cycle
t_csl
t_csh
t_asu
t_ah
t_dsu
t_dh
Table 6.8 TX Data FIFO Direct PIO Write Timing
DESCRIPTION
Write Cycle Time
nCS, nWR Assertion Time
nCS, nWR Deassertion Time
Address, FIFO_SEL Setup to nCS, nWR Assertion
Address, FIFO_SEL Hold Time
Data Setup to nCS, nWR Deassertion
Data Hold Time
MIN
TYP
45
32
13
0
0
7
0
MAX
UNITS
ns
ns
ns
ns
ns
ns
ns
Note: A TX Data FIFO Direct PIO Write cycle begins when both nCS and nWR are asserted. The
cycle ends when either or both nCS and nWR are deasserted. They may be asserted and
deasserted in any order.
Revision 1.5 (07-11-08)
126
DATASHEET
SMSC LAN9117