M306H2MC-XXXFP Datasheet, PDF (190/210 Pages) Renesas Technology Corp – SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER with DATA ACQUISITION CONTROLLER

MITSUBISHI MICROCOMPUTERS
M306H2MC-XXXFP
SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER
with DATA ACQUISITION CONTROLLER
Table 4.5 Electrical characteristics (referenced to VCC = 5V, VSS = 0V at Ta = 25^oC unless otherwise specified)
Symbol
RfXIN
RfXCIN
V RAM
I cc
Parameter
Feedback resistance XIN
Feedback resistance XCIN
RAM retention voltage
Power supply current
Measuring condition
Standard
Min Typ. Max.
1.0
6.0
When clock is stopped
2.0
At the time of slicer operation f(XCIN)=10kHz
150 180
VCC=5.0V f(XCIN)=32kHz A rectangular wave (Notes 1, 2)
90.0
VCC=3.0V f(XCIN)=32kHz A rectangular wave (Notes 1, 2)
40.0
VCC=5.0V f(XCIN)=32kHz At the time of weight (Notes 1, 2)
5.0
10.0
VCC=3.0V f(XCIN)=32kHz At the time of weight (Notes 1, 2)
3.0
8.0
At the time of a clock stop (Notes 2)
5.0
Unit
MΩ
MΩ
V
mA
µA
µA
µA
µA
µA
Note 1: This is a state where only one timer is operating with fc32 while the oscillation capability is set to
LOWand slicer operation is turned OFF.
Note 2: • VDD1, VDD2, and VDD3 all are at the same potential level as VCC.
• Extension register (address 0016 DD8) STBY0 and (address 1516 DD13) STBY1 are set to 1
while all other extension registers (addresses 0016 through 2216) are set to 0.
• Clock input to the FSCIN pin is disabled.
• Inputs to the SYNCIN and CVIN1 pins are disabled.
Tabl 4.6 Video signal input conditions (VCC = 5.0V, Ta = –20 to 70^oC)
Symbol
VIN-cu
Parameter
Composite video signal input clamp voltage
Measuring condition
Sync-chip voltage
Standard
Min Typ. Max.
Unit
1.0
V
Rev. 1.0
189