M306H2MC-XXXFP Datasheet, PDF(142/210 Page) Renesas Technology Corp – SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER with DATA ACQUISITION CONTROLLER

English

English German Russian Spanish Italian Polish Chinese Japanese Korean French Portuguese	Language :

M306H2MC-XXXFP Datasheet, PDF (142/210 Pages) Renesas Technology Corp – SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER with DATA ACQUISITION CONTROLLER

◁

MITSUBISHI MICROCOMPUTERS

M306H2MC-XXXFP

SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER

with DATA ACQUISITION CONTROLLER

(a) Sample and hold

Sample and hold is selected by setting bit 0 of the A-D control register 2 (address 03D416) to â1â.

When sample and hold is selected, the rate of conversion of each pin increases. As a result, a 28 fAD

cycle is achieved. Sample and hold can be selected in all modes. However, in all modes, be sure to

specify before starting A-D conversion whether sample and hold is to be used.

(b) Extended analog input pins

In one-shot mode and repeat mode, the input via the extended analog input pins ANEX0 and ANEX1

can also be converted from analog to digital.

When bit 6 of the A-D control register 1 (address 03D716) is â1â and bit 7 is â0â, input via ANEX0 is

converted from analog to digital. The result of conversion is stored in A-D register 0.

When bit 6 of the A-D control register 1 (address 03D716) is â0â and bit 7 is â1â, input via ANEX1 is

converted from analog to digital. The result of conversion is stored in A-D register 1.

(c) External operation amp connection mode

In this mode, multiple external analog inputs via the extended analog input pins, ANEX0 and ANEX1,

can be amplified together by just one operation amp and used as the input for A-D conversion.

When bit 6 of the A-D control register 1 (address 03D716) is â1â and bit 7 is â1â, input via AN0 to AN7

is output from ANEX0. The input from ANEX1 is converted from analog to digital and the result stored

in the corresponding A-D register. The speed of A-D conversion depends on the response of the

external operation amp. Do not connect the ANEX0 and ANEX1 pins directly. Figure 2.12.9 is an

example of how to connect the pins in external operation amp mode.

Resistor ladder

Analog

input

AN0

AN1

AN2

AN3

AN4

AN5

AN6

AN7

Successive conversion register

ANEX0

ANEX1

External op-amp

Figure 2.12.9 Example of external op-amp connection mode

Comparator

Rev. 1.0

141

▷