M306H2MC-XXXFP Datasheet, PDF (106/210 Pages) Renesas Technology Corp – SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER with DATA ACQUISITION CONTROLLER

MITSUBISHI MICROCOMPUTERS
M306H2MC-XXXFP
SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER
with DATA ACQUISITION CONTROLLER
• Example of transmit timing (when internal clock is selected)
Tc
Transfer clock
“1”
Transmit enable
bit (TE)
“0”
Transmit buffer ^{“1”}
empty flag (Tl)
“0”
“H”
CTSi
“L”
CLKi
Data is set in UARTi transmit buffer register
Transferred from UARTi transmit buffer register to UARTi transmit register
TCLK
Stopped pulsing because CTS = “H”
Stopped pulsing because transfer enable bit = “0”
TxDi
Transmit
“1”
register empty
flag (TXEPT)
“0”
Transmit interrupt ^{“1”}
request bit (IR) “0”
D0 D1 D2 D3 D4 D5 D6 D7
D0 D1 D2 D3 D4 D5 D6 D7
D0 D1 D2 D3 D4 D5 D6 D7
Shown in ( ) are bit symbols.
Cleared to “0” when interrupt request is accepted, or cleared by software
The above timing applies to the following settings:
• Internal clock is selected.
• CTS function is selected.
• CLK polarity select bit = “0”.
• Transmit interrupt cause select bit = “0”.
Tc = TCLK = 2(n + 1) / fi
fi: frequency of BRGi count source (f1, f8, f32)
n: value set to BRGi
• Example of receive timing (when external clock is selected)
“1”
Receive enable
bit (RE)
“0”
“1”
Transmit enable
bit (TE)
“0”
Transmit buffer ^{“1”}
empty flag (Tl) “0”
“H”
RTSi
“L”
Dummy data is set in UARTi transmit buffer register
Transferred from UARTi transmit buffer register to UARTi transmit register
1 / fEXT
CLKi
Receive data is taken in
RxDi
D0 D1 D2 D3 D4 D5 D6 D7
D0 D1 D2 D3 D4 D5
Receive complete ^{“1”}
flag (Rl)
“0”
Transferred from UARTi receive register
to UARTi receive buffer register
Read out from UARTi receive buffer register
Receive interrupt ^{“1”}
request bit (IR) “0”
Cleared to “0” when interrupt request is accepted, or cleared by software
Shown in ( ) are bit symbols.
The above timing applies to the following settings:
Meet the following conditions are met when the CLK
Figure 2.11.11 Typical transmit/receive timings in clock synchronous serial I/O mode
Rev. 1.0
105