M306H2MC-XXXFP Datasheet, PDF (124/210 Pages) Renesas Technology Corp – SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER with DATA ACQUISITION CONTROLLER

MITSUBISHI MICROCOMPUTERS
M306H2MC-XXXFP
SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER
with DATA ACQUISITION CONTROLLER
Some other functions added are explained here. Figure 2.11.28 shows their workings.
Bit 4 of the UART2 special mode register is used as the bus collision detect sampling clock select bit.
The bus collision detect interrupt occurs when the RxD2 level and TxD2 level do not match, but the
nonconformity is detected in synchronization with the rising edge of the transfer clock signal if the bit
is set to “0”. If this bit is set to “1”, the nonconformity is detected at the timing of the overflow of timer A0
rather than at the rising edge of the transfer clock.
Bit 5 of the UART2 special mode register is used as the auto clear function select bit of transmit enable
bit. Setting this bit to “1” automatically resets the transmit enable bit to “0” when “1” is set in the bus
collision detect interrupt request bit (nonconformity).
Bit 6 of the UART2 special mode register is used as the transmit start condition select bit. Setting this
bit to “1” starts the TxD transmission in synchronization with the falling edge of the RxD terminal.
1. Bus collision detect sampling clock select bit (Bit 4 of the UART2 special mode register)
0: Rising edges of the transfer clock
CLK
TxD/RxD
Timer A0
1: Timer A0 overflow
2. Auto clear function select bit of transmt enable bit (Bit 5 of the UART2 special mode register)
CLK
TxD/RxD
Bus collision
detect interrupt
request bit
Transmit
enable bit
3. Transmit start condition select bit (Bit 6 of the UART2 special mode register)
0: In normal state
CLK
TxD
Enabling transmission
With "1: falling edge of RxD2" selected
CLK
TxD
RxD
Figure 2.11.28 Some other functions added
Rev. 1.0
123