MC68HC908JL3E Datasheet, PDF (119/226 Pages) Motorola, Inc – Microcontrollers

Monitor ROM (MON)
Security
9.5 Security
A security feature discourages unauthorized reading of FLASH locations
while in monitor mode. The host can bypass the security feature at
monitor mode entry by sending eight security bytes that match the bytes
at locations $FFF6–$FFFD. Locations $FFF6–$FFFD contain user-
defined data.
NOTE: Do not leave locations $FFF6–$FFFD blank. For security reasons,
program locations $FFF6–$FFFD even if they are not used for vectors.
During monitor mode entry, the MCU waits after the power-on reset for
the host to send the eight security bytes on pin PTB0. If the received
bytes match those at locations $FFF6–$FFFD, the host bypasses the
security feature and can read all FLASH locations and execute code
from FLASH. Security remains bypassed until a power-on reset occurs.
If the reset was not a power-on reset, security remains bypassed and
security code entry is not required. (See Figure 9-7.)
V_DD
RST
4096 + 32 OSCXCLK CYCLES
24 BUS CYCLES
PTB0
FROM HOST
FROM MCU
1
4
1
1
2
4
1
NOTES:
1 = Echo delay, 2 bit times
2 = Data return delay, 2 bit times
4 = Wait 1 bit time before sending next byte.
Figure 9-7. Monitor Mode Entry Timing
MC68H(R)C908JL3E/JK3E/JK1E — Rev. 2.0
MOTOROLA
Monitor ROM (MON)
Technical Data
119