English
Language : 

MC68HC908JL3E Datasheet, PDF (102/226 Pages) Motorola, Inc – Microcontrollers
Oscillator (OSC)
8.3 X-tal Oscillator (MC68HC908JL3E/JK3E/JK1E)
The X-tal oscillator circuit is designed for use with an external crystal or
ceramic resonator to provide accurate clock source.
In its typical configuration, the X-tal oscillator is connected in a Pierce
oscillator configuration, as shown in Figure 8-1. This figure shows only
the logical representation of the internal components and may not
represent actual circuitry. The oscillator configuration uses five
components:
• Crystal, X1
• Fixed capacitor, C1
• Tuning capacitor, C2 (can also be a fixed capacitor)
• Feedback resistor, RB
• Series resistor, RS (optional)
From SIM
To SIM
2OSCOUT
To SIM
OSCOUT
SIMOSCEN
XTALCLK
÷2
MCU
OSC1
RB
OSC2
X1
C1
RS*
*RS can be zero (shorted) when used with higher-frequency crystals.
Refer to manufacturer’s data.
See Section 18. for component value requirements.
C2
Figure 8-1. X-tal Oscillator External Connections
Technical Data
102
Oscillator (OSC)
MC68H(R)C908JL3E/JK3E/JK1E — Rev. 2.0
MOTOROLA