D20419-80 Datasheet, PDF (363/386 Pages) ITT Industries – Military/Aerospace

Environmental D
Contact Crimping Information
Crimp Type Contacts
Contact
Size
20
Wire Size
Accom.
20, 22, 24
Standard Finish
Pin
Socket
330-5291-015
031-1007-000
Military Finish
Pin
Socket
330-5291-079
031-1007-042
Semi-Automatic Crimp Machines
D*D
Insertion/Extraction Tools
Contact
Size
20
AWG
20, 22, 24
Plastic Insertion/Extraction
Part No.
Description
980-2000-426
CIET-20HD
CIET-20HD
Plastic Extraction
Part No.
Description
323-7010-000
CET-20-11
Hand Crimp Tools
Contact
Size
20
AWG
20, 22, 24
M22520/1-01
Crimp Tool
Part No.
Description
995-0001-584
M22520/2-01
995-0001-585
M22520/1-01
M22520/2-01
Locator
Part No.
Description
995-0001-604
M22520/2-08
995-0001-244
TH25
Assembly Instructions
Wire Stripping-
Machined Contacts
A
Contact Crimping
CBT-646
The CBT-646, Vibra-Bowl Crimper is a pneumat-
ically powered, electoronically controlled machine. It
is designed to semi-automatically crimp closed
barrel, machined contacts, as used in the aerospace
and commercial industries. The machine will ac-
commodate wire sizes 30 thru 12 AWG. The
CBT-646 is actuated automatically upon insertion
of a pre-stripped stranded or single conductor wire.
The CBT-646 meets all Mil. Spec. requirements for
crimping closed barrel contacts.
Machine Crimp Rage: 1300 + per hour
Power Requirements:
Electrical = 115 Vac, 60 Hz, 5A
Pneumatic = 85 psi, 2 cu. ft. per min.
Products: Most ITT Cannon Commercial and Aero-
space closed-barrel contacts, wire sizes 30 thru 12
AWG. See connector line for part numbers.
Contact Insertion
A
Min.
Max.
.188 (4.78)
.208 (5.28)
1. Cut wires to length. Strip insulation per above illustration. Check
for broken or frayed wires.
2. Insert contact and wires into poper crimp tool (and locator, if 3. Center wired contact in groove of insertion tool with tool tip
required). Crimp contact to wires. Inspect crimp.
butting contact shoulder. Insert contact into cavity until a positive
stop is felt. Inspection insertion.
Contact Extraction
4. To be sure contact is locked securely, pull back lightly on wire.
Repeat for balance of contacts working row by row across the
insulator.
5. Place wire into extraction tool tip.
6. Insert tool tip into contact cavity until tip bottoms against contact
shoulder, releasing tines. Hold wires against tool with finger and
remove tool and contact. Repeat for balance of contacts.
Dimensions are shown in inches (millimeters).
Dimensions subject to change.
www.ittcannon.com
363