D20419-80 Datasheet, PDF (223/386 Pages) ITT Industries – Military/Aerospace

MIL-C-28840 Connectors
KFS Aluminum Bronze (AB)Series, Corrosion Resistant
The KFS/AB/Series of connecting devices has been
developed specifically for long term corrosion re-
sistance without sacrificing mechanical strength or
electrical requirements. The AB series is capable of
withstanding at least 10,000 hours of salt spray
without noticeable change in performance and is
completely intermatable/intermountable with
their aluminum and stainless steel counterparts. All
MIL-C-28840 parameters have been maintained.
Applications include - Navy shipboard, both above
and below decks, submersibles including ROV's,
towed bodies and submarines for military/defence
and R&D/leisure applicatoins.
SERIES
ITTCC DESIGNATOR
KFS / AB / 16 A J I P I
AB: CORROSION RESISTANT
SHELL STYLE (see page 219)
CLAS-Not applicable to AB Series
SHELL SIZE
INSERT ARRANGEMENT
CONTACT STYLE
POLARIZATION
KFS/SB Series
This series features a solder zone for braided cable
and a lip to accommodate a shrink boot. The
standard M28840 is threaded to accept a large
metal backshell for the very heavy MIL-C-915 type
cables. Recently, low smoke, halogen free cable has
been introduced which is quite flexible and does not
need a heavy backshell. EMI shielding effectiveness
has been greatly enhance by soldering the braid
directly to the connector
Note: All M28840 parameters (including tooling)
have been maintained.
KFS / SB / A A I P I
ITTCC DESIGNATION
SERIES
SB: SOLDER/STRAP ZONE WITH
ACCOMMODATION FOR A
SHRINK BOOT
CLASS (see page 219)
SHELL SIZE DESIGNATOR
INSERT DESIGNATOR
CONTACT STYLE (see page???)
POLARIZATION
KFS/CB Connector Saver Series
KFS/CSF Connector Saver with flange
KFS/TBR Connector Saver thru-bulkhead receptacle
This series of connecting devices is used to protect
the M28840/KFS receptacle interface (either pin
or socket) from damage. The TBR series is a
thru-bulkhead receptacle which allows cable plugs
to be wired and tested prior to final assembly. Plugs
are then mated to the mounted TBR connector to
complete teh installation.
The connector saver, connector saver with flange
and thru-bulkhead receptacle all feature a hard
dielectric insert assembly with lead-in chamfers for
positive alignment of pins and sockets. Environ-
mental sealing is maintained per MIL-C-28840 by
way of a gasket seal under the coupling nut mecha-
nism. The series conforms to all parameters out-
lined in MIL-C-28840 and is intened to be used in
areas of extreme abuse. A clear cadmium over
nickel plate identifies the CS series from standard
product.
SERIES
KFS / CB / A J I P I
ITT CANNON DESIGNATOR
CS-CONENCTOR SAVER
CSF-CS WITH FLANGE
TBR-THRU-BULKHEAD RECEPTACLE
CLASS (see page 219)
SHELL SIZE DESIGNATOR
INSERT ARRANGEMENT
*P-PIN SIDE IN RECEPTACLE
*S-SOCKET SIDE IN RECEPTACLE
POLARIZATION
KFS
Dimensions are shown in inches (millimeters).
Dimensions subject to change.
www.ittcannon.com
223