D20419-80 Datasheet, PDF (285/386 Pages) ITT Industries – Military/Aerospace

Environmental Double Density D - .075" Contact Spacing
Standard Mount (Continued)
Plug/Socket Connector
2DDD100S
.690
(17.53)
MAX.
.064 (1.63)
.058 (1.47)
(REF)
.428 (10.87)
.423 (10.74)
.094 (2.39)
.084 (2.13)
.312 (7.92)
.296 (7.52)
.740
(18.80)
MAX.
2.864
(72.75)
MAX.
2.255
(57.28)
MAX.
.190 (4.83)
.173 (4.39)
FROM INSULATOR
.600
(15.24)
MAX.
2D*D
Panel Cutout
2.536 (64.41)
2.526 (64.16)
All tolerances are +_ .010 (0.25) unless noted otherwise.
.122 (3.10)
.118 (3.00)
DIA. TYP.
USE .120(3.05) DIA. HOLE OR 4-40 TAP (CUSTOMER PREFERENCE) FOR FRONT MOUNTING
FOR REAR MOUNTING USE .120(3.05) DIA. HOLE COUNTERSUNK FOR FLATHEAD SCREW.
.083(2.11) R. MAX.
F
TYPICAL
E
D
C
A
Mounting Dimensions
.189 +_ .015*
(4.80 +_ 0.38)
REAR
PLUG
.292 +_ .010*
(7.42 +_ 0.25)
FRONT
Shell
Size
A
+_ .010 (0.25)
C
Min.
2DDD-100
2.859 (72.62)
2.265 (57.53)
Note: Panel cutout does not allow for potting cup clearance.
.133 +_ 0.10*
(3.38 +_ 0.25)
PLUG
.324 +_ .010*
(8.23 +_ 0.25)
D
+_ .010 (0.25)
.735 (18.67)
.230 +_ .013*
(5.84 +_ 0.32)
REAR
E
Min.
.610 (15.49)
F
+_ .006 (0.15)
2.531 (64.29)
PLUG
.230 +_ .013*
FRONT ^{(5.84 +_ 0.32)}
RECEPT
RECEPT
RECEPT
Figure 1
Figure 2
1. With both connectors rear mounted, use #4-
40 flat head screws flush with the panel.
2. With both connectors front mounted, use
#4-40 binder or pan head screws.
Figure 3
Figure 4
3. With both connectors rear mounted (float
mounting on either plug or receptacle side),
use #4-40 flat head screws, flush with the
panels.
4. With both connectors front mounted (float
mounting on either plug or receptacle side),
use #4-40 binder or pan head screws.
Figure 5
Figure 6
5/6. With plug assembly front mounted and re-
ceptacle assembly rear mounted, use hard-
ware from Figures 5 and 6. If float mounting
is desired, use Figure 3 or 4 for the float
mounted connector.
*Dimensions between panels represent the recommended limit to be used in the design of the connector mounting method.
NOTE: Max. panel thickness is .125 (3.17) for non-floating rear panel mounting.
Dimensions are shown in inches (millimeters).
Dimensions subject to change.
www.ittcannon.com
285