D20419-80 Datasheet, PDF (317/386 Pages) ITT Industries – Military/Aerospace

MIL-C-81659 Rack and Panel Filter Connectors
TDPX
How to Order - Multiple Gang
FILTER SERIES INDICATOR
T - Transverse Monolith
SERIES PREFIX
DPX - DPX series with solder termination.
GANGS IN SHELL
2, 3, and 4 gang
ENVIRONMENTAL
E - For interfacial (pin)
Delete for standard.
CONTACT ARRANGEMENT
See page 31 for applicable arrangements. Please
specify each arrangement number as indicated in
ordering nomenclature for 2, 3, or 4 gang.
T DPX 4 E - 57 T P 57 N P 57 M P 57 L P - 34 - 00 01
FILTER SERIES INDICATOR
SERIES PREFIX
GANGS IN SHELL
ENVIRONMENTAL
CONTACT ARRANGEMENT
(Side A)
FILTER TYPE
CONTACT TYPE
CONTACT ARRANGEMENT
(Side B)
FILTER TYPE
CONTACT TYPE
CONTACT ARRANGEMENT
(Side C)
FILTER TYPE
CONTACT TYPE
CONTACT ARRANGEMENT
(Side D)
CAPACITANCE INDICATOR
CONTACT TYPE
SHELL TYPE
MODIFICATION NUMBER
POLARIZING POSITION
CAPACITANCD INDICATOR (Each gang, as desired)*
L - Low Frequency
M - Mid Frequency
T - Standard Frequency
Note: Use of "T" omitted in past nomen-
clature
H - High Frequency
N - No filter this gang. Standard DPX insert
assembly.
CONTACT TYPE
P for pin; S for socket. Designation follows each
arrangement as ordered for 2, 3, or 4 gang
versions. (Printed circuit contact/termiation is
available. Consult factory for specifications.)
SHELL TYPE
33B for male (ARINC B)
34B for female (ARINC B)
33 for male
34 for female
Note: ARINC B specified for DPX2 only.
POLARIZING POSITION (see pages 67-68)
The last two digits in the four-digit dash number
refer to the polarizing post position. When the last
two digits are omitted, the polarizing posts will be
assembled in position 01, but the position number
is not stamped on the connector. This allows the
customer to position the posts themselves nd
then stamp the appropriate number on the shell. If
the last two digits are 00, the polarizing posts are
deleted.
MODIFICATION NUMBERS
- 0001 indicates standard design for all styles.
TDPX2-33B:
- 0301 - Mounting holes .120 dia.
Countersunk 100˚ to .230 dia.
TDPX2-34:
- 0101 -
With #4-40 clinch nuts in mounting
holes.
TDPX3-34:
- 0101 -
With 6 #4-40 clunch nuts in mount-
ing holes.
TDPX4-34:
- 0101 -
With 10 #4-40 clinch nuts in
mounting holes.
Dimensions are shown in inches (millimeters).
Dimensions subject to change.
www.ittcannon.com
317