81348 Datasheet, PDF (77/89 Pages) Intel Corporation – Two Integrated Intel XScale processors

Electrical Specifications—Intel^® 81348
4.3.7 PCI Express* Differential Receiver (Rx) Input Specifications
Table 30.
PCI Express* Rx Input Specifications
Symbol
Parameter
Min. Nom Max Units Notes
V_DIFFp-p
Differential input voltage
0.175
1.200 V 1
J_TOTAL
Total Output Jitter.
0.65 UI 2
V_CM-AC
AC Common Mode
100 mV 3
T_Reye
Receiver eye opening.
0.35
UI 4
RL-Diff_RX
Differential Return Loss
15
dB 5
RL-CM_TX
Common Mode Return Loss
6
dB 5
Z_RX-OUT-DC DC Differential Output Impedance
90 100 110 Ω 6
Z_RX-Match-DC D+/D- impedance matching
0-5
+5 % 7
V_RX-SQUELCH Squelch detect threshold
75
175 mV 8
Cin_RX
AC coupled
400
pf 9
L_SKEW-RX
Lane to Lane Skew at Rx
20 UI 10
Notes:
1. PSeeaekF-Pigeuarked1i2ff.erential voltage. V_DIFFp-p = 2 * V_RMAx. Measured at the package pins of the receiver.
2. Max Jitter tolerated by Rx. This is the nominal value tolerated at the package pin of the receiver
device. A receiver must therefore tolerate any additional jitter generated by the package to the die.
43.. SPeeaekFcigoumrem2o4n,m“Roedceevivaelur ^eE.y|eVODp⁺e+ninVg^D-(|D/2iff-eVre^Cn^Mt^-i^Da^Cl)⁽”^avo^gn⁾ page 84.
5. 50 MHz to 1.6 GHz. The driver output impedance shall result in a differential return loss greater than
or equal to 15 dB and a common mode return loss greater than or equal to 6 dB over a frequency
rrcaeonfmegrmeenoocnfe5m0imoMdpeHedz(ait.noec.1ea.8sfomGr Hreeazt.suuTrrnheisdloosbusytmpaueVtaeismcutporeermdNaeenntcwtesorirsekq1Au0ni0rael_Ωmyzfeeonrrtwdaiiptffhpelr1iee0sn0ttioa_{Ωladrlelifvtfuearrlniednlootiusastlppaurntodlbe2evs5e)l.Ω}s.NfToohtree
this is based on a
Applicable during
nominal PCI Express* interconnect
active (L0) and Align states only.
differential
characteristic
impedance
of
100
Ω.
6. DC Differential Mode Impedance 100 Ω ±10% tolerance.
7. DC impedance matching between two lanes of a port.
8. Peak to Peak value. Measured at the pin of the receiver. Differential signal below this level will indicate
a squelch condition.
9. All receivers shall be AC coupled to the media.
10. Lane skew at the Receiver that must be tolerated.
December 2007
Order Number: 315038-003US
Intel^® 81348 I/ODParotacsehsesoert
77