English
Language : 

MC9S08LC60 Datasheet, PDF (327/358 Pages) Freescale Semiconductor, Inc – Microcontrollers
Appendix A Electrical Characteristics
Table A-4. DC Characteristics (Sheet 3 of 3)
(Temperature Range = -40 to 85°C Ambient)
Parameter
Symbol
Min
Typical(1)
Max
Unit
dc injection current(4), (5), (6), (7), (8)
VIN < VSS, VIN > VDD
Single pin limit
|IIC|
—
Total MCU limit, includes sum of all stressed pins
—
0.2
mA
5
mA
Input capacitance (all non-supply pins)(2)
CIn
—
7
pF
1 Typicals are measured at 25°C.
2 This parameter is characterized and not tested on each device.
3 Measurement condition for pull resistors: VIn = VSS for pullup and VIn = VDD for pulldown.
4 Power supply must maintain regulation within operating VDD range during instantaneous and operating maximum current
conditions. If positive injection current (VIn > VDD) is greater than IDD, the injection current may flow out of VDD and could result
in external power supply going out of regulation. Ensure external VDD load will shunt current greater than maximum injection
current. This will be the greatest risk when the MCU is not consuming power. Examples are: if no system clock is present, or
if clock rate is very low which would reduce overall power consumption.
5 All functional non-supply pins are internally clamped to VSS and VDD.
6 Input must be current limited to the value specified. To determine the value of the required current-limiting resistor, calculate
resistance values for positive and negative clamp voltages, then use the larger of the two values.
7 This parameter is characterized and not tested on each device.
8 IRQ does not have a clamp diode to VDD. Do not drive IRQ above VDD.
Pull Up Resistance
36
34
32
30
28
26
24
22
20
1.8
2
2.3
2.7
3
3.6
VDD (V)
-40C
25C
70C
85C
Pull Down Resistance
34
32
30
28
26
24
22
20
1.8
2
2.3
2.7
3
3.6
VDD (V)
-40C
25C
70C
85C
Figure A-1. Pullup and Pulldown Typical Resistor Values (VDD = 3.0 V)
MC9S08LC60 Series Advance Information Data Sheet, Rev. 2
Freescale Semiconductor
PRELIMINARY
327