MC68HC908QL4 Datasheet, PDF (198/226 Pages) Motorola, Inc – Microcontrollers

Development Support
16.3.1.4 Data Format
Communication with the monitor ROM is in standard non-return-to-zero (NRZ) mark/space data format.
Transmit and receive baud rates must be identical.
START
BIT BIT 0
BIT 1 BIT 2 BIT 3 BIT 4 BIT 5
NEXT
START
BIT 6 BIT 7 STOP BIT
BIT
Figure 16-13. Monitor Data Format
16.3.1.5 Break Signal
A start bit (0) followed by nine 0 bits is a break signal. When the monitor receives a break signal, it drives
the PTA0 pin high for the duration of approximately two bits and then echoes back the break signal.
MISSING STOP BIT
APPROXIMATELY 2 BITS DELAY
BEFORE ZERO ECHO
01234567
01234567
Figure 16-14. Break Transaction
16.3.1.6 Baud Rate
The monitor communication baud rate is controlled by the frequency of the external or internal oscillator
and the state of the appropriate pins as shown in Table 16-1.
Table 16-1 also lists the bus frequencies to achieve standard baud rates. The effective baud rate is the
bus frequency divided by 256 when using an external oscillator. When using the internal oscillator in
forced monitor mode, the effective baud rate is the bus frequency divided by 335.
16.3.1.7 Commands
The monitor ROM firmware uses these commands:
• READ (read memory)
• WRITE (write memory)
• IREAD (indexed read)
• IWRITE (indexed write)
• READSP (read stack pointer)
• RUN (run user program)
The monitor ROM firmware echoes each received byte back to the PTA0 pin for error checking. An 11-bit
delay at the end of each command allows the host to send a break character to cancel the command. A
delay of two bit times occurs before each echo and before READ, IREAD, or READSP data is returned.
The data returned by a read command appears after the echo of the last byte of the command.
NOTE
Wait one bit time after each echo before sending the next byte.
MC68HC908QL4 Data Sheet, Rev. 7
198
Freescale Semiconductor