MC68HC908QL4 Datasheet, PDF (183/226 Pages) Motorola, Inc – Microcontrollers

15.8.4 TIM Channel Status and Control Registers
Each of the TIM channel status and control registers does the following:
• Flags input captures and output compares
• Enables input capture and output compare interrupts
• Selects input capture, output compare, or PWM operation
• Selects high, low, or toggling output on output compare
• Selects rising edge, falling edge, or any edge as the active input capture trigger
• Selects output toggling on TIM overflow
• Selects 0% and 100% PWM duty cycle
• Selects buffered or unbuffered output compare/PWM operation
Registers
Read:
Write:
Reset:
Bit 7
CH0F
0
0
6
CH0IE
0
5
MS0B
0
4
MS0A
0
3
ELS0B
0
2
ELS0A
0
1
TOV0
0
Bit 0
CH0MAX
0
Figure 15-9. TIM Channel 0 Status and Control Register (TSC0)
Read:
Write:
Reset:
Bit 7
CH1F
0
0
6
5
0
CH1IE
0
0
= Unimplemented
4
MS1A
0
3
ELS1B
0
2
ELS1A
0
1
TOV1
0
Bit 0
CH1MAX
0
Figure 15-10. TIM Channel 1 Status and Control Register (TSC1)
CHxF — Channel x Flag Bit
When channel x is an input capture channel, this read/write bit is set when an active edge occurs on
the channel x pin. When channel x is an output compare channel, CHxF is set when the value in the
counter registers matches the value in the TIM channel x registers.
Clear CHxF by reading the TSCx register with CHxF set and then writing a 0 to CHxF. If another
interrupt request occurs before the clearing sequence is complete, then writing 0 to CHxF has no
effect. Therefore, an interrupt request cannot be lost due to inadvertent clearing of CHxF.
Writing a 1 to CHxF has no effect.
1 = Input capture or output compare on channel x
0 = No input capture or output compare on channel x
CHxIE — Channel x Interrupt Enable Bit
This read/write bit enables TIM interrupt service requests on channel x.
1 = Channel x interrupt requests enabled
0 = Channel x interrupt requests disabled
MSxB — Mode Select Bit B
This read/write bit selects buffered output compare/PWM operation. MSxB exists only in the TSC0.
Setting MS0B causes the contents of TSC1 to be ignored by the TIM and reverts TCH1 to
general-purpose I/O.
1 = Buffered output compare/PWM operation enabled
0 = Buffered output compare/PWM operation disabled
MC68HC908QL4 Data Sheet, Rev. 7
Freescale Semiconductor
183