MC68HC908GR8A_07 Datasheet, PDF (125/260 Pages) Freescale Semiconductor, Inc – Microcontrollers

Port D
T1CH1 and T1CH0 — Timer 1 Channel I/O Bits
The PTD5/T1CH1–PTD4/T1CH0 pins are the TIM1 input capture/output compare pins. The edge/level
select bits, ELSxB and ELSxA, determine whether the PTD5/T1CH1–PTD4/T1CH0 pins are timer
channel I/O pins or general-purpose I/O pins. See Chapter 17 Timer Interface Module (TIM1 and
TIM2).
SPSCK — SPI Serial Clock
The PTD3/SPSCK pin is the serial clock input of the SPI module. When the SPE bit is clear, the
PTD3/SPSCK pin is available for general-purpose I/O.
MOSI — Master Out/Slave In
The PTD2/MOSI pin is the master out/slave in terminal of the SPI module. When the SPE bit is clear,
the PTD2/MOSI pin is available for general-purpose I/O.
MISO — Master In/Slave Out
The PTD1/MISO pin is the master in/slave out terminal of the SPI module. When the SPI enable bit,
SPE, is clear, the SPI module is disabled, and the PTD0/SS pin is available for general-purpose I/O.
Data direction register D (DDRD) does not affect the data direction of port D pins that are being used
by the SPI module. However, the DDRD bits always determine whether reading port D returns the
states of the latches or the states of the pins. See Table 12-5.
SS — Slave Select
The PTD0/SS pin is the slave select input of the SPI module. When the SPE bit is clear, or when the
SPI master bit, SPMSTR, is set, the PTD0/SS pin is available for general-purpose I/O. When the SPI
is enabled, the DDRB0 bit in data direction register B (DDRB) has no effect on the PTD0/SS pin.
12.5.2 Data Direction Register D
Data direction register D (DDRD) determines whether each port D pin is an input or an output. Writing a 1
to a DDRD bit enables the output buffer for the corresponding port D pin; a 0 disables the output buffer.
Address:
Read:
Write:
Reset:
$0007
Bit 7
0
6
DDRD6
5
DDRD5
4
DDRD4
3
DDRD3
2
DDRD2
1
DDRD1
0
0
0
0
0
0
0
= Unimplemented
Figure 12-14. Data Direction Register D (DDRD)
Bit 0
DDRD0
0
DDRD6–DDRD0 — Data Direction Register D Bits
These read/write bits control port D data direction. Reset clears DDRD6–DDRD0, configuring all port D
pins as inputs.
1 = Corresponding port D pin configured as output
0 = Corresponding port D pin configured as input
NOTE
Avoid glitches on port D pins by writing to the port D data register before
changing data direction register D bits from 0 to 1.
MC68HC908GR8A • MC68HC908GR4A Data Sheet, Rev. 5
Freescale Semiconductor
125