10-503140-032 Datasheet, PDF (40/437 Pages) Amphenol Corporation – The Interconnection Leader

D38999/29 & D38999/30 – Series III
Amphenol
TV Breakaway Fail Safe Lanyard Release Plug
Aerospace
Step 6. Military/
Commercial
Lanyard Length Code
Table II
Lanyard
Length
(in.) ±
.236
4.016
4.528
5.000
5.512
6.024
6.535
7.008
7.520
7.992
8.503
9.016
9.528
10.000
10.512
11.024
11.535
12.008
12.520
13.031
14.016
15.000
16.024
17.008
18.031
Lanyard
Length
(mm) ± 6.0
102
115
127
140
153
166
178
191
203
216
229
242
254
267
280
293
305
318
331
356
381
407
432
458
Lanyard
Length
Code
For Part
Number
A
B
C
D
E
F
G
H
I
J
K
L
M
N
P
R
S
T
U
V
W
X
Y
Z
Step 7. Military
Alternate Keying Position
For alternate positions of
connector (to prevent
cross-mating) see alternate
positioning on page 24.
(N indicates normal)
Easy Steps to build a part number... Commercial
FAIL SAFE 88-5565( ) & 91-5565( )
Ordering procedure for example part number 88-556529-EP is shown below:
1.
2.
3.
4.
5.
6.
Service Connector Type Shell Size & Required Lanyard Contact Type/Alter-
Class Identification Insert Arrg. Code Field Length Code nate Keying Position
88
5565
29
0
E
P
Step 1. Select a Service Class
88
Designates corrosion resistant olive drab cadmium plate over nickel, 500
hour extended salt spray, EMI –50dB @ 10 GHz specification min., 175°C
91
Designates electroless nickel plated aluminum, optimum EMI shielding ef-
fectiveness –65dB @ 10 GHz specification min., 48 hour salt spray, 200°C
These are standard finishes. Consult Amphenol Aerospace, Sidney, NY for other variations.
Step 2. Select a Connector Type Identification
5565 Designates MIL-DTL-38999, Series III Tri-Start Lanyard Release Plug
Step 3. Select a Commercial Shell Size &
Insert Arrangement Code
MIL-DTL-38999, see insert availability chart on page 38.
Step 4. Required Field
0 The required field is always a 0
Step 5. Select a Lanyard Length Code
See Table II (to the left) for lanyard length code number.
Step 6. Select a Contact Type/Alternate Keying Position
P designates pin, S designates socket for normal positioning of contacts. When
an alternate position of the connector is required to prevent cross-mating, a
different letter (other than P or S) is used. See alternate positioning on page 24,
then convert to Amphenol Commercial coding by the following chart.
Pin Contacts
Socket Contacts
MS Letter Amphenol letter MS Letter Amphenol Letter
PN
P (normal)
SN
S (normal)
PA
G
SA
H
PB
I
SB
J
PC
K
SC
L
PD
M
SD
N
PE
R
SE
T
Contact Amphenol Aerospace for more information at 800-678-0141 • www.amphenol-aerospace.com 39