10-503140-032 Datasheet, PDF (371/437 Pages) Amphenol Corporation – The Interconnection Leader

Amp_Ah_ee_ron_spo_acl_e
Coax Contacts with Frequency
Range of DC to 40 GHz
HIGH FREQUENCY
COAX CONTACTS WITH
“FLOAT MOUNT”
TECHNOLOGY
Amphenol Aerospace now offers DC
to 40 GHz size 8 coaxial contacts for
the D38999 housing and standard
inserts. These contacts can be
terminated to a multiple of cable types
High Frequency Size 8 Coax
Contacts with “Float Mount“
Technology
depending on the application.
By using standard interfaces that are based on MIL-STD-348 and can be
installed in any D38999 size 8 insert, Amphenol has transformed the circular
connector industry. This technology expands the use of D38999 connectors to
include the microwave transmission lines within the multi-port configuration
without change to a custom connector.
The high frequencies are maintained by Amphenol’s unique “Float Mount”
technology. This technology allows for consistent microwave performance while
maintaining tight mechanical tolerances. This consistency provides superior
electrical performance and, unlike other blindmate connectors, will maintain an
accurate phase length when mated. See page 396 for specifications,
performances and ordering of this contact.
HF38999 - D38999 Connectors with
High Frequency Coax Contacts
Twinax Contacts for Printed
Circuit Board Applications
PC TAIL TWINAX
CONTACTS
Amphenol provides Printed
Circuit Tail Twinax contacts for
MIL-DTL-38999 Series I and III
circular connectors and also for
ARINC 404 and ARINC 600
rectangular connectors. High
reliability is assured with factory
pre-assembled contacts and
standardized termination
Variety of PC Tail Twinax Contacts
to the board.
See pages 401-403 for performance data and ordering of PC tail twinax
contacts, and consult Amphenol Aerospace for further information needed. Also
see the Printed Circuit Board, and the Series I, II, III section for MIL-DTL-38999
connectors.
Shielded Triax Contacts
D38999 Connectors
with PC Tail
Twinax
Contacts
Printed Circuit Twinax Contacts provide
a cost effective packaging solution for
limited space applications where
connectors are attached to printed
circuit boards.
TRIAX CONTACTS WITH
THREE CONDUCTORS FOR
USE WITH TRIAX CABLE
Amphenol supplies sizes 8, 10 and 12
triax contacts for use in MIL-DTL-38999
Series I, II and III connectors. Triax con-
Triax Contacts
tacts provide additional shielding when terminated to triax
cable having solid or stranded center conductors. See cable compatibility in
the Cable Usage Guide and performance data and ordering of triax contacts
on pages 400-403. Each of the three conductors of the triax contact is separated by
dielectric insulation to isolate ground planes and to improve shielding
effectiveness. All conductors are crimp terminated for high reliability and ease of
assembly. Triax contacts may be specified for direct connection to printed circuit
boards. For maximum system flexibility, triax contacts may be mixed
with coax, twinax and power contacts in a single connector.
5
Rail Launch MIL-STD-1760
Connector with
Triax Contacts
370 Contact Amphenol Aerospace for more information at 800-678-0141 • www.amphenol-aerospace.com