Z8S18020FSC Datasheet, PDF (1/70 Pages) Zilog, Inc. – ENHANCED Z180 MICROPROCESSOR

PRELIMINARY PRODUCT SPECIFICATION
1
Z80180/Z8S180/
1
Z8L180 SL1919
ENHANCED Z180 MICROPROCESSOR
FEATURES
s Code Compatible with Zilog Z80^® CPU
s Extended Instructions
s Two Chain-Linked DMA Channels
s Low Power-Down Modes
s On-Chip Interrupt Controllers
s Three On-Chip Wait-State Generators
s On-Chip Oscillator/Generator
s Expanded MMU Addressing (up to 1 MB)
s Clocked Serial I/O Port
s Two 16-Bit Counter/Timers
s Two Enhanced UARTs (up to 512 Kbps)
s Clock Speeds: 6, 8, 10, 20, 33 MHz
s Operating Range: 5V (3.3V@ 20 MHz)
s Operating Temperature Range: 0^°C to +70^°C
s -40^°C to +85^°C Extended Temperature Range
s Three Packaging Styles
– 68-Pin PLCC
– 64-Pin DIP
– 80-Pin QFP
GENERAL DESCRIPTION
The enhanced Z80180/Z8S180/Z8L180^™ significantly im-
proves on the previous Z80180 models while still providing
full backward compatibility with existing Zilog Z80 devices.
The Z80180/Z8S180/Z8L180 now offers faster execution
speeds, power saving modes, and EMI noise reduction.
This enhanced Z180 design also incorporates additional
feature enhancements to the ASCIs, DMAs, and I_cc
STANDBY Mode power consumption. With the addition of
“ESCC-like” Baud Rate Generators (BRGs), the two ASCIs
now have the flexibility and capability to transfer data asyn-
chronously at rates of up to 512 Kbps. In addition, the ASCI
receiver has added a 4-byte First In First Out (FIFO) which
can be used to buffer incoming data to reduce the inci-
dence of overrun errors. The DMAs have been modified to
allow for a “chain-linking” of the two DMA channels when
set to take their DMA requests from the same peripherals
device. This feature allows for non-stop DMA operation be-
tween the two DMA channels, reducing the amount of CPU
intervention (Figure 1).
Not only does the Z80180/Z8S180/Z8L180 consume less
power during normal operations than the previous model,
it has also been designed with three modes intended to fur-
ther reduce the power consumption. Zilog reduced I_cc pow-
er consumption during STANDBY Mode to a minimum of
10 µA by stopping the external oscillators and internal
clock. The SLEEP mode reduces power by placing the
CPU into a “stopped” state, thereby consuming less cur-
rent while the on-chip I/O device is still operating. The
SYSTEM STOP mode places both the CPU and the on-
chip peripherals into a “stopped” mode, thereby reducing
power consumption even further.
A new clock doubler feature has been implemented in the
Z80180/Z8S180/Z8L180 device that allows the program-
mer to double the internal clock from that of the external
clock. This provides a systems cost savings by allowing
the use of lower cost, lower frequency crystals instead of
the higher cost, and higher speed oscillators.
The Enhanced Z180 is housed in 80-pin QFP, 68-pin
PLCC, and 64-pin DIP packages.
DS971800401
PRELIMINARY
1-1