W83L517D_05 Datasheet, PDF (87/133 Pages) Winbond – LPC I/O for Notebook

W83L517D/W83L517D-F
Bit 2:
TX_FCS
0
1
RX_DM - Receiver Demodulation Mode.
RX_DM
0
1
Selected Frequency
30K ~ 56K Hz
400K ~ 480K Hz
Demodulation Mode
Enable internal decoder
Disable internal decoder
Bit 1~0:
TX_MM1~0 - Transmitter Modulation Mode 1~0
TX_MM1~0
TX Modulation Mode
00
Continuously send pulse for logic 0
01
8 pulses for logic 0 and no pulse for logic 1.
10
6 pulses for logic 0 and no pulse for logic 1
11
Reserved.
8.9.4 Set7.Reg3 - Sets Select Register (SSR)
REG.
BIT 7
BIT 6
BIT 5
BIT 4
BIT 3
BIT 2
BIT 1
BIT 0
SSR
Bit 7
Bit 6
Bit 5
Bit 4
Bit 3
Bit 2
Bit 1
Bit 0
Default Value
1
1
1
1
0
1
0
0
Reading this register returns F4H. Select Register Set by writing a set number to this register.
8.9.5 Set7.Reg4 - Infrared Module (Front End) Select 1 (IRM_SL1)
Reg.
Bit 7
Bit 6
Bit 5
Bit 4
Bit 3
Bit 2
Bit 1
Bit 0
IRM_SL1 IR_MSP SIR_SL2 SIR_SL1 SIR_SL0
-
AIR_SL2 AIR_SL1 AIR_SL0
Default Value
0
0
0
0
0
0
0
0
Bit 7:
Bit 6~4:
IR_MSP - IR Mode Select Pulse
When set to 1, the transmitter (IRTX) will send a 64 μs pulse to setup a special IR front-
end operational mode. When IR front-end module uses mode select pin (MD) and
transmitter IR pulse (IRTX) to switch between high speed IR (such as FIR or MIR) and
low speed IR (SIR or ASK-IR), this bit should be used.
SIR_SL2~0 - SIR (Serial IR) mode select.
These bits are used to program the operational mode of the SIR front-end module.
These values of SIR_SL2~0 will be automatically loaded to pins of IR_SL2~0,
respectively, when (1) AM_FMT=1 (Automatic Format, in Set7.Reg7.Bit7); (2) the mode
of Advanced IR is set to SIR (AD_MD2~0, in Set0.Reg4.Bit7~0).
- 87 -
Publication Release Date: May 23, 2005
Revision 1.0