W83L517D_05 Datasheet, PDF (100/133 Pages) Winbond – LPC I/O for Notebook

W83L517D/W83L517D-F
Bit 5-3: Reflect the IRQ resource assigned for ECP port.
cnfgB[5:3]
IRQ resource
000
reflect other IRQ resources selected by PnP register (default)
001
IRQ7
010
IRQ9
011
IRQ10
100
IRQ11
101
IRQ14
110
IRQ15
111
IRQ5
Bit 2-0: These five bits are at high level during a read and can be written.
9.3.10 ecr (Extended Control Register) Mode = all
This register controls the extended ECP parallel port functions. The bit definitions are follows:
7 6543210
empty
full
service Intr
dmaEn
nErrIntrEn
MODE
MODE
MODE
Bit 7-5: These bits are read/write and select the mode.
000
Standard Parallel Port mode. The FIFO is reset in this mode.
PS/2 Parallel Port mode. This is the same as 000 except that direction may be used
001
to tri-state the data lines and reading the data register returns the value on the data
lines and not the value in the data register.
Parallel Port FIFO mode. This is the same as 000 except that bytes are written or
010
DMAed to the FIFO. FIFO data are automatically transmitted using the standard
parallel port protocol. This mode is useful only when direction is 0.
ECP Parallel Port Mode. When the direction is 0 (forward direction), bytes placed
into the ecpDFifo and bytes written to the ecpAFifo are placed in a single FIFO and
011
auto transmitted to the peripheral using ECP Protocol. When the direction is 1
(reverse direction), bytes are moved from the ECP parallel port and packed into
bytes in the ecpDFifo.
100
Selects EPP Mode. In this mode, EPP is activated if the EPP mode is selected.
101
Reserved.
- 100 -